Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-12-01T00:27:31.907Z Has data issue: false hasContentIssue false
  • English
  • Français

Electrical properties of SnO2:Sb ultrathin films prepared by colloidal deposition process

Published online by Cambridge University Press:  13 January 2016

Tiago G. Conti ,
Adenilson J. Chiquito  and
Edson R. Leite
Tiago G. Conti
Affiliation:
LIEC, Department of Chemistry, Federal University of São Carlos, São Carlos, São Paulo 13565-905, Brazil
Adenilson J. Chiquito
Affiliation:
NanoLab, Department of Physics, Federal University of São Carlos, São Carlos, São Paulo 13565-905, Brazil
Edson R. Leite*
Affiliation:
LIEC, Department of Chemistry, Federal University of São Carlos, São Carlos, São Paulo 13565-905, Brazil
*
a) Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

In the present work, we are investigating the electronic transport mechanism for antimony-doped tin oxide (ATO) ultrathin films produced by a colloidal deposition process (CDP) of nanocrystals synthesized via a solvothermal route in organic medium. The ATO ultrathin films were prepared from nanoparticles containing 9 mol% of Sb and the observed electrical resistivity at room temperature was 1.55, 1.10 × 10−1, and 1.83 × 10−3 Ω cm, respectively, for the 40, 45, and 71 nm films. X-ray diffraction, transmission electron microscopy, scanning electron microscopy, and atomic force microscopy were carried out to investigate the films and electrical resistivity measurements taken in the four-probe mode with temperature ranging from −260 to 27 °C (13–300 K ± 0.1 K). Results show a good data fitting on Mott's two-dimensional (2D) noninteracting variable range hopping for the 45 nm thin film, which is not further observed for the ATO ultrathin films obtained from CDP.

Keywords

nanocrystalline materialselectrical propertiesnon-aqueous synthesissol–gel
Type
Articles
Information
Journal of Materials Research , Volume 31 , Issue 1: Annual Issue: Early Career Scholars in Materials Science , 14 January 2016 , pp. 148 - 153
Copyright
Copyright © Materials Research Society 2016 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Kovalenko, M.V., Manna, L., Cabot, A., Hens, Z., Talapin, D.V., Kagan, C.R., Klimov, V.I., Rogach, A.L., Reiss, P., Milliron, D.J., Guyot-Sionnnest, P., Konstantatos, G., Parak, W.J., Hyeon, T., Korgel, B.A., Murray, C.B., and Heiss, W.: Prospects of nanoscience with nanocrystals. ACS Nano 9, 1012 (2015).CrossRefGoogle ScholarPubMed
Gonçalves, R.H. and Leite, E.R.: The colloidal nanocrystal deposition process: An advanced method to prepare high performance hematite photoanodes for water splitting. Energy Environ. Sci. 7, 2250 (2014).CrossRefGoogle Scholar
Gonçalves, R.H., Leite, L.D.T., and Leite, E.R.: Colloidal WO3 nanowires as a versatile route to prepare a photoanode for solar water splitting. ChemSusChem 5, 234 (2012).Google ScholarPubMed
Gonçalves, R.H., Lima, B.H.R., and Leite, E.R.: Magnetite colloidal nanocrystals: A facile pathway to prepare mesoporous hematite thin films for photoelectrochemical water splitting. J. Am. Chem. Soc. 133, 6012 (2011).Google Scholar
Pinheiro, A.N., Firmiano, E.G.S., Rabelo, A.C., Dalmaschio, C.J., and Leite, E.R.: Revisiting SrTiO3 as a photoanode for water splitting: Development of thin films with enhanced charge separation under standard solar irradiation. RSC Adv. 4, 2029 (2014).CrossRefGoogle Scholar
Conti, T.G., Chiquito, A.J., da Silva, R.O., Longo, E., and Leite, E.R.: Electrical properties of highly conducting SnO2:Sb nanocrystals synthesized by a nonaqueous sol–gel method. J. Am. Ceram. Soc. 93, 3862 (2010).Google Scholar
Batzill, M. and Diebold, U.: The surface and materials science of tin oxide. Prog. Surf. Sci. 79, 47 (2005).CrossRefGoogle Scholar
Amma, D.S.D., Vaidyan, V.K., and Manoj, P.K.: Structural, electrical and optical studies on chemically deposited tin oxide films from inorganic precursors. Mater. Chem. Phys. 93, 194 (2005).Google Scholar
Singh, A.V., Mehra, R.M., Yoshida, A., and Wakahara, A.: Doping mechanism in aluminum doped zinc oxide films. J. Appl. Phys. 95, 3640 (2004).Google Scholar
Fattakhova-Rohlfing, D., Brezesinski, T., Rathouský, J., Feldhoff, A., Oekermann, T., Wark, M., and Smarsly, B.: Transparent conductive films of indium tin oxide with 3D mesopore architecture. Adv. Mater. 18, 2980 (2006).CrossRefGoogle Scholar
James, K., Schweizer, H.P., and Kern, W.: Chemical vapor deposition of antimony-doped tin oxide films formed from dibutyl tin diacetate. J. Electrochem. Soc.: Solid State Sci. Technol. 123, 270 (1976).Google Scholar
Shanthi, E., Dutta, V., Banerjee, A., and Chopra, K.L.: Electrical and optical properties of undoped and antimony-doped tin oxide films. J. Appl. Phys. 51, 6243 (1980).Google Scholar
Kaneko, H. and Miyake, K.: Physical properties of antimony-doped tin oxide thick films. J. Appl. Phys. 53, 3629 (1982).Google Scholar
Kim, K.H. and Lee, S.W.: Effect of antimony addition on electrical and optical properties of tin oxide film. J. Am. Ceram. Soc. 77, 915 (1994).Google Scholar
Terrier, C., Chatelon, J.P., and Roger, J.A.: Electrical and optical properties of Sb:SnO2 thin films obtained by the sol–gel method. Thin Solid Films 295, 95 (1997).CrossRefGoogle Scholar
Rajpure, K.Y., Kusumade, M.N., Neumann-Spallart, M.N., and Bhosale, C.H.: Effect of Sb doping on properties of conductive spray deposited SnO2 thin films. Mater. Chem. Phys. 64, 184 (2000).Google Scholar
Tsukuma, K., Akiyama, T., and Imai, H.: Hydrolysis deposition of thin films of antimony-doped tin oxide. J. Am. Ceram. Soc. 84, 869 (2001).Google Scholar
Thangaraju, B.: Structural, and electrical studies on highly conducting spray deposited fluorine and antimony doped SnO2 thin films from SnCl2 precursor. Thin Solid Films 402, 71 (2002).Google Scholar
Elangovan, E. and Ramamurthi, K.: A study on low cost-high conducting fluorine and antimony-doped tin oxide thin films. Appl. Surf. Sci. 249, 183 (2005).Google Scholar
Zhang, J., Gao, L., and Chen, M.: Spark plasma sintering of high-density antimony-doped tin oxide ceramics from nanoparticles. J. Am. Ceram. Soc. 89, 3874 (2006).CrossRefGoogle Scholar
Giraldi, T.R., Escote, M.T., Maciel, A.P., Longo, E., Leite, E.R., and Varela, J.A.: Transport and sensors properties of nanostructured antimony-doped tin oxide films. Thin Solid Films 515, 2678 (2006).Google Scholar
Müller, V., Rasp, M., Stefanic, G., Ba, J., Günther, S., Rathousky, J., Niederberger, M., and Fattakhova-Rohlfing, D.: Highly conducting nanosized monodispersed antimony-doped tin oxide particles synthesized via nonaqueous sol–gel procedure. Chem. Mater. 21, 5229 (2009).Google Scholar
Wang, Y., Brezesinski, T., Antonietti, M., and Smarsly, B.: Ordered mesoporous Sb-, Nb-, and Ta-doped SnO2 thin films with adjustable doping levels and high electrical conductivity. ACS Nano 3, 1373 (2009).Google Scholar
Luo, L., Bozyigit, D., Wood, V., and Niederberger, M.: High-quality transparent electrodes spin-cast from preformed antimony-doped tin oxide nanocrystals for thin film optoelectronics. Chem. Mater. 25, 4901 (2013).Google Scholar
Hoel, C.A., Mason, T.O., Gaillard, J.F., and Poeppelmeier, K.R.: Transparent conducting oxides in the ZnO-In2O3-SnO2 system. Chem. Mater. 22, 3569 (2010).Google Scholar
Niederberger, M.: Nonaqueous sol–gel routes to metal oxide nanoparticles. Acc. Chem. Res. 40, 793 (2007).CrossRefGoogle ScholarPubMed
Ba, J.H., Polleux, J., Antonietti, M., and Niederberger, M.: Non-aqueous synthesis of tin oxide nanocrystals and their assembly into ordered porous mesostructures. Adv. Mater. 17, 2509 (2005).Google Scholar
Pinna, N.: The benzyl alcohol route: An elegant approach towards organic–inorganic hybrid nanomaterials. J. Mater. Chem. 17, 2769 (2007).Google Scholar
Skoromets, V., Nemec, H., Kopecek, J., Kuzel, P., Peters, K., Fattakhova-Rohlfing, D., Vetushka, A., Muller, M., Ganzerova, K., and Fejfar, A.: Conductivity mechanisms in Sb-doped SnO2 nanoparticle assemblies: DC and terahertz regime. J. Phys. Chem. C 119, 19485 (2015).Google Scholar