Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-24T18:48:09.771Z Has data issue: false hasContentIssue false
  • English
  • Français

Effects of volatilization of lithium on hydrogen storage characteristics of Mg–Ni–Li alloy

Published online by Cambridge University Press:  18 October 2019

Chih-Ting Wu ,
Jen-Hao Liu  and
Te-Hui Tsai
Chih-Ting Wu
Affiliation:
Department of Vehicle Engineering, Army Academy R.O.C., Jhongli, Taoyuan 32092, Taiwan
Jen-Hao Liu
Affiliation:
Graduated of Institute of Material Science and Engineering, National Central University, Jhongli, Taoyuan 32001, Taiwan
Te-Hui Tsai*
Affiliation:
Department of Mechanical Engineering, Army Academy R.O.C., Taoyuan 32092, Jhongli, Taiwan
*
a)Address all correspondence to this author. e-mail: [email protected]
Get access

Abstract

Lithium was added to the hypereutectic Mg–Ni alloy to investigate the effect of volatilization of Li on the hydrogen storage characteristics of the eutectic Mg–Ni alloy at 300 °C. After fully activated at 300 °C, Li was almost completely volatilized and the structure of Li-containing Mg82Ni18 alloy was converted to the structure of Li-free Mg82Ni18 alloy, but hydrogen absorption capacity significantly decreased. This is because volatilization of Li weakened the bonding between eutectic Mg and Mg2Ni, lowering the catalytic effect of Mg2Ni on Mg. The decrease in hydrogen absorption capacity was more obvious with increasing Li content. In addition, experimental alloy in powder form could increase surface area, causing Li to volatilize at 300 °C.

Keywords

volatilization of lithiumhydrogen storage characteristicsMg–Ni–Li alloyXRD
Type
Article
Information
Journal of Materials Research , Volume 34 , Issue 20 , 28 October 2019 , pp. 3583 - 3588
Copyright
Copyright © Materials Research Society 2019 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

Footnotes

b)

Present Address: Army Academy R.O.C., Jhongli District, Taoyuan 32092, Taiwan.

References

Seiler, A., Schlapbach, L., Waldkirch, T.V., Shaltiel, D., and Stucki, F.: Surface analysis of Mg2Ni–Mg, Mg2Ni, and Mg2Cu. J. Less-Common Met. 73, 193 (1980).CrossRefGoogle Scholar
Reilly, J.J. and Wiswall, R.H.: The reaction of hydrogen with alloys of magnesium and nickel and the formation of Mg2NiH4. Inorg. Chem. 7, 2254 (1968).CrossRefGoogle Scholar
Yim, C.D., You, B.S., Na, Y.S., and Bae, J.S.: Hydriding properties of Mg–xNi alloys with different microstructures. Catal. Today 120, 276 (2007).CrossRefGoogle Scholar
Liang, G., Boily, S., Huot, J., Neste, A.V., and Schulz, R.: Mechanical alloying and hydrogen absorption properties of the Mg–Ni system. J. Alloys Compd. 267, 302 (1998).CrossRefGoogle Scholar
Satyapal, S., Petrovic, J., Read, C., Thomas, G., and Ordaz, G.: The U.S. Department of Energy’s National Hydrogen Storage Project: Progress towards meeting hydrogen-powered vehicle requirements. Catal. Today 120, 246 (2007).CrossRefGoogle Scholar
Yang, H., Yuan, H., Ji, J., Sun, H., Zhou, Z., and Zhang, Y.: Characteristics of Mg2Ni0.75M0.25 (M = Ti, Cr, Mn, Fe, Co, Ni, Cu and Zn) alloys after surface treatment. J. Alloys Compd. 330, 640 (2002).CrossRefGoogle Scholar
Song, M.Y., Kwon, S., Bae, J.S., and Hong, S.H.: Hydrogen-storage properties of Mg–23.5Ni–(0 and 5) Cu prepared by melt spinning and crystallization heat treatment. Int. J. Hydrogen Energy 33, 1711 (2008).CrossRefGoogle Scholar
Chuntonov, K., Setina, J., Ivanov, A., and Permikin, D.: New lithium gas sorbent III. Experimental data on evaporation. J. Alloys Compd. 460, 357 (2008).CrossRefGoogle Scholar
Gupta, M. and Gupta, R.P.: First principles study of the destabilization of Li amide–imide reaction for hydrogen storage. J. Alloys Compd. 446, 319 (2007).CrossRefGoogle Scholar
Liang, G.: Synthesis and hydrogen storage properties of Mg-based alloys. J. Alloys Compd. 370, 123 (2004).CrossRefGoogle Scholar
Nachman, J.F. and Rohy, D.A.: Proceedings of the Miami International Symposium on Metal–Hydrogen Systems, Miami Beach, FL, 13–15 April 1981 (Pergamon Press, New York, 1982); pp. 557–600.Google Scholar
Nayeb-Hashemi, A.A. and Clark, J.B.: The Mg–Mn (magnesium–manganese) system. Bull. Alloy Phase Diagrams 6, 238 (1985).CrossRefGoogle Scholar
Massalski, T.B., Murray, J.L., Benett, L.H., and Baker, H.: Binary Alloy Phase Diagrams (American Society for Metals, Metals Park, Ohio, 1990).Google Scholar