Hostname: page-component-cd9895bd7-jn8rn Total loading time: 0 Render date: 2024-12-20T08:39:42.695Z Has data issue: false hasContentIssue false
  • English
  • Français

Translation groups of the boundary-layer flows induced by continuous moving surfaces

Published online by Cambridge University Press:  27 May 2010

EUGEN MAGYARI
EUGEN MAGYARI*
Affiliation:
Institut für Hochbautechnik, ETH Zürich, Wolfgang-Pauli Strasse 1, CH-8093 Zürich, Switzerland
*
†Email address for correspondence: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

The steady plane boundary-layer flows of velocity field {u(x, y), v(x, y)} induced by continuous moving surfaces are revisited in this paper. It is shown that the governing balance equations, as well as the asymptotic condition u(x, ∞) = 0 at the outer edge of the boundary layer are invariant under arbitrary translations y → y + y0(x) of the transverse coordinate y. The wall conditions, i.e. the prescribed stretching velocity u(x, 0) ≡ Uw(x) and the transpiration velocity v(x, 0) ≡ Vw(x) distributions, however, undergo in general substantial changes. The consequences of this basic symmetry property on the structure of the solution space are investigated. It is found that starting with a primary solution which describes the boundary-layer flow induced by an impermeable surface, infinitely many translated solutions can be generated which form a continuous group, the translation group of the given primary solution. The elements of this group describe boundary-layer flows induced by permeable surfaces stretching under transformed wall conditions, Uw(x) → Ũw(x) = u[x, y0(x)] and Vw(x) → Ṽw(x) = v[x, y0(x)] − y′0(x)u[x, y0(x)], respectively. In this way, starting with a known solution {u(x, y), v(x, y)} so that the inverse y0(x) = u−1(x, Ũw) of u[x, y0(x)] exists, a new solution {ũ(x, y), ṽ(x, y)} corresponding to any desired stretching velocity distribution Ũw(x) can be prepared. It also turns out that several exact solutions discovered during the latter decades are not basically new solutions, but translated counterparts of some formerly reported primary solutions. A few specific examples are discussed in detail.

Type
Papers
Information
Journal of Fluid Mechanics , Volume 655 , 25 July 2010 , pp. 327 - 343
Copyright
Copyright © Cambridge University Press 2010

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Acroyd, J. A. D. 1967 On the laminar compressible boundary layer with stationary origin on a moving flat wall. J. Fluid Mech. 63, 871–888.Google Scholar
Afzal, N. & Varshney, I. S. 1980 The cooling of a low heat resistance stretching sheet moving through a fluid. Wärme-Stoffübertrag. 14, 289–293.CrossRefGoogle Scholar
Ali, M. E. 1995 On thermal boundary layer on a power law stretched surface with suction and injection. Intl J. Heat Fluid Flow 16, 280–290.CrossRefGoogle Scholar
Altan, T., Oh, S. & Gegel, H. 1979 Metal Forming Fundamentals and Applications. American Society of Metals.Google Scholar
Banks, W. H. H. 1983 Similarity solutions of the boundary layer equations for a stretching wall. J. Méc. Theor. Appl. 2, 375–392.Google Scholar
Bickley, W. G. 1937. The plane jet. Phil. Mag. 23, 727–731.CrossRefGoogle Scholar
Chen, C. K. & Char, M. 1988 Heat transfer of a continuous stretching surface with suction and blowing. J. Math. Anal. Appl. 135, 248–250.CrossRefGoogle Scholar
Cheng, P. & Minkowycz, W. J. 1977 Free convection about a vertical flat plate embedded in a porous medium with application to heat transfer from a dike. J. Geophys. Res. 82, 2040–2044.CrossRefGoogle Scholar
Crane, L. E. 1970 Flow past a stretching plane. J. Appl. Math. Phys. (ZAMP) 21, 645–647.CrossRefGoogle Scholar
Fang, T & Zhang, J. 2010 Thermal boundary layers over a shrinking sheet: an analytical solution. Acta Mech. 209, 325–343.CrossRefGoogle Scholar
Fisher, E. G. 1976 Extrusion of Plastics. Wiley.Google Scholar
Fox, V. G., Erickson, L. E. & Fan, L. T. 1968 Methods for solving the boundary layer equations for moving continuous flat surfaces with suction and injection. AIChE J. 14, 726–736.CrossRefGoogle Scholar
Goldstein, S. 1939 A note on the boundary layer equations. Proc. Camb. Phil. Soc. 35, 338–340.CrossRefGoogle Scholar
Goldstein, S. 1965 On backward boundary layers and flow in converging passages. J. Fluid Mech. 21, 33–45.CrossRefGoogle Scholar
Grubka, L. J. & Bobba, K. M. 1985 Heat transfer characteristics of a continuous stretching surface with variable temperature. J. Heat Transfer 107, 248–250.CrossRefGoogle Scholar
Gupta, P. S. & Gupta, A. S. 1977 Heat and mass transfer on a stretching sheet with suction or blowing. Can. J. Chem. Engng 55, 744–746.CrossRefGoogle Scholar
Ingham, D. B. & Brown, S. N. 1986 Flow past a suddenly heated vertical plate in a porous medium. Proc. R. Soc. Lond. A 403, 51–80.Google Scholar
Kuiken, H. K. 1981 On boundary layer in fluid mechanics that decay algebraically along stretches of wall that are not vanishingly small. IMA J. Appl. Math. 27, 387–405.CrossRefGoogle Scholar
Liao, S. J. 2006 Series solutions of unsteady boundary-layer flows over a stretching flat plate. Stud. Appl. Math. 117, 239–263.CrossRefGoogle Scholar
Liao, S. J. & Magyari, E. 2006 Exponentially decaying boundary layers as limiting cases of families of algebraically decaying ones. J. Appl. Math. Phys. (ZAMP) 57, 777–792.CrossRefGoogle Scholar
Magyari, E. 2008 The Entrainment Theorem for wall driven boundary layer flows. Acta Mec. 201, 119–129.CrossRefGoogle Scholar
Magyari, E., Ali, M. E. & Keller, B. 2001 Heat and mass transfer characteristics of the self-similar boundary-layer flows induced by continuous surfaces stretched with rapidly decreasing velocities. Heat Mass Transfer 38, 65–74.CrossRefGoogle Scholar
Magyari, E. & Keller, B. 1999 Heat and mass transfer in the boundary layers on an exponentially stretching continuous surface. J. Phys. D: Appl. Phys. 32, 2876–2881.CrossRefGoogle Scholar
Magyari, E. & Keller, B. 2000 Exact solutions for self-similar boundary-layer flows induced by permeable stretching walls. Eur. J. Mech. B/Fluids 19, 109–122.CrossRefGoogle Scholar
Magyari, E. & Keller, B. 2001 The free jets as boundary layer flows induced by continuous stretching surfaces. Heat Mass Transfer 38, 111–114.CrossRefGoogle Scholar
Magyari, E. & Keller, B. 2004 Backward free convection boundary layers in porous media. Transp. Porous Media 55, 285–300.CrossRefGoogle Scholar
Magyari, E. & Keller, B. 2005 A direct method to calculate the heat transfer coefficient of steady similar boundary layer flows induced by continuous moving surfaces. Intl J. Therm. Sci. 44, 245–254.CrossRefGoogle Scholar
Magyari, E., Pop, I. & Keller, B. 2002 a The missing self-similar free convection boundary layer flow over a vertical surface in a porous medium. Transp. Porous Media 46, 91–102.CrossRefGoogle Scholar
Magyari, E., Pop, I. & Keller, B. 2002 b The missing similarity boundary-layer flow over a moving plane surface. J. Appl. Math. Phys. (ZAMP) 53, 782–793.CrossRefGoogle Scholar
Magyari, E., Pop, I. & Keller, B. 2003 New analytical solutions of a well known boundary value problem in fluid mechanics. Fluid Dyn. Res. 33, 351–355.CrossRefGoogle Scholar
Magyari, E. & Rees, D. A. S. 2006 Effect of viscous dissipation on the Darcy free convection flow over a vertical plate with exponential temperature distribution in a porous medium. Fluid Dyn. Res. 38, 405–429.CrossRefGoogle Scholar
Magyari, E. & Rees, D. A. S. 2008 The Entrainment Theorem for the Darcy free convection over a permeable vertical plate. Intl J. Therm. Sci. 47, 1123–1130.CrossRefGoogle Scholar
Merkin, J. H. 1984 A note on the solution of a differential equation arising in boundary-layer theory. J. Engng Math. 18, 31–36.CrossRefGoogle Scholar
Pop, I. & Ingham, D. B. 2001 Convective Heat Transfer: Mathematical and Computational Modelling of Viscous Fluids and Porous Media. Pergamon.Google Scholar
Sakiadis, B. C. 1961. Boundary-layer behavior on continuous solid surfaces. AIChE J. 7, 26–28. See also pp. 221–225 and 467–472.CrossRefGoogle Scholar
Tadmor, Z. & Klein, I. 1970 Engineering Principles of Plasticating Extrusion. Polymer Science and Engineering Series. Van Norstrand Reinhold.Google Scholar
Tsou, F. K., Sparrow, E. M. & Goldstein, R. J. 1967 Flow and heat transfer in the boundary layer on a continuous moving surface. Intl J. Heat Mass Transfer 10, 219–235.CrossRefGoogle Scholar
Vleggaar, J. 1977 Laminar boundary layer behavior on continuous, accelerating surfaces. Chem. Engng Sci. 32, 1517–1525.CrossRefGoogle Scholar
Weidman, P. D. & Magyari, E. 2010 Generalized Crane flows induced by continuous surfaces stretching with arbitrary velocities. Acta Mech. 209, 353–362.CrossRefGoogle Scholar