Hostname: page-component-586b7cd67f-l7hp2 Total loading time: 0 Render date: 2024-11-28T19:30:32.089Z Has data issue: false hasContentIssue false

Transition to turbulence in the rotating-disk boundary-layer flow with stationary vortices

Published online by Cambridge University Press:  11 December 2017

E. Appelquist
Affiliation:
Linné FLOW Centre, KTH Mechanics, SE-100 44 Stockholm, Sweden Swedish e-Science Research Centre (SeRC), SE-100 44 Stockholm, Sweden
P. Schlatter*
Affiliation:
Linné FLOW Centre, KTH Mechanics, SE-100 44 Stockholm, Sweden Swedish e-Science Research Centre (SeRC), SE-100 44 Stockholm, Sweden
P. H. Alfredsson
Affiliation:
Linné FLOW Centre, KTH Mechanics, SE-100 44 Stockholm, Sweden
R. J. Lingwood
Affiliation:
Linné FLOW Centre, KTH Mechanics, SE-100 44 Stockholm, Sweden Division of Engineering Science, School of Engineering and Materials Science, Queen Mary University of London, Mile End Road, London E1 4NS, UK
*
Email address for correspondence: [email protected]

Abstract

This paper proposes a resolution to the conundrum of the roles of convective and absolute instability in transition of the rotating-disk boundary layer. It also draws some comparison with swept-wing flows. Direct numerical simulations based on the incompressible Navier–Stokes equations of the flow over the surface of a rotating disk with modelled roughness elements are presented. The rotating-disk flow has been of particular interest for stability and transition research since the work by Lingwood (J. Fluid Mech., vol. 299, 1995, pp. 17–33) where an absolute instability was found. Here stationary disturbances develop from roughness elements on the disk and are followed from the linear stage, growing to saturation and finally transitioning to turbulence. Several simulations are presented with varying disturbance amplitudes. The lowest amplitude corresponds approximately to the experiment by Imayama et al. (J. Fluid Mech., vol. 745, 2014a, pp. 132–163). For all cases, the primary instability was found to be convectively unstable, and secondary modes were found to be triggered spontaneously while the flow was developing. The secondary modes further stayed within the domain, and an explanation for this is a proposed globally unstable secondary instability. For the low-amplitude roughness cases, the disturbances propagate beyond the threshold for secondary global instability before becoming turbulent, and for the high-amplitude roughness cases the transition scenario gives a turbulent flow directly at the critical Reynolds number for the secondary global instability. These results correspond to the theory of Pier (J. Engng Maths, vol. 57, 2007, pp. 237–251) predicting a secondary absolute instability. In our simulations, high temporal frequencies were found to grow with a large amplification rate where the secondary global instability occurred. For smaller radial positions, low-frequency secondary instabilities were observed, tripped by the global instability.

Type
JFM Papers
Copyright
© 2017 Cambridge University Press 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Appelquist, E.2014 Direct numerical simulations of the rotating-disk boundary-layer flow. Licentiate thesis, Royal Institute of Technology, KTH Mechanics.Google Scholar
Appelquist, E.2017 The rotating-disk boundary-layer flow studied through numerical simulations. Doctoral thesis, Royal Institute of Technology, KTH Mechanics.CrossRefGoogle Scholar
Appelquist, E., Imayama, S., Alfredsson, P. H., Schlatter, P. & Lingwood, R. J. 2016a Linear disturbances in the rotating-disk flow: a comparison between results from simulations, experiments and theory. Eur. J. Mech. (B/Fluids) 55, 170181.CrossRefGoogle Scholar
Appelquist, E., Schlatter, P., Alfredsson, P. H. & Lingwood, R. J. 2015 Global linear instability of the rotating-disk flow investigated through simulations. J. Fluid Mech. 765, 612631.CrossRefGoogle Scholar
Appelquist, E., Schlatter, P., Alfredsson, P. H. & Lingwood, R. J. 2016b On the global nonlinear instability of the rotating-disk flow over a finite domain. J. Fluid Mech. 803, 332355.CrossRefGoogle Scholar
Balachandar, S., Streett, C. L. & Malik, M. R. 1992 Secondary instability in rotating-disk flow. J. Fluid Mech. 242, 323347.CrossRefGoogle Scholar
Brynjell-Rahkola, M., Shahriari, N., Schlatter, P., Hanifi, A. & Henningson, D. S. 2017 Stability and sensitivity of a crossflow-dominated Falkner-Skan-Cooke boundary layer with discrete surface roughness. J. Fluid Mech. 826, 830850.CrossRefGoogle Scholar
Davies, C. & Carpenter, P. W. 2003 Global behaviour corresponding to the absolute instability of the rotating-disc boundary layer. J. Fluid Mech. 486, 287329.CrossRefGoogle Scholar
Davies, C., Thomas, C. & Carpenter, P. W. 2007 Global stability of the rotating-disk boundary layer. J. Engng Maths 57, 219236.CrossRefGoogle Scholar
Fischer, P. F., Lottes, J. W. & Kerkemeier, S. G.2012 Nek5000. Available at: http://nek5000.mcs.anl.gov.Google Scholar
Gregory, N., Stuart, J. T. & Walker, W. S. 1955 On the stability of three-dimensional boundary layers with application to the flow due to a rotating disk. Phil. Trans. R. Soc. Lond. A 248, 155199.Google Scholar
Ho, J., Corke, T. C. & Matlis, E. 2016 Effect of wall suction on rotating disk absolute instability. J. Fluid Mech. 791, 704737.CrossRefGoogle Scholar
Högberg, M. & Henningson, D. S. 1998 Secondary instability of cross-flow vortices in Falkner–Skan–Cooke boundary layers. J. Fluid Mech. 368, 339357.CrossRefGoogle Scholar
Hosseini, S. M., Tempelmann, D., Hanifi, A. & Henningson, D. S. 2013 Stabilization of a swept-wing boundary layer by distributed roughness elements. J. Fluid Mech. 718, R1.CrossRefGoogle Scholar
Hussain, Z., Garrett, S. J. & Stephen, S. O. 2011 The instability of the boundary layer over a disk rotating in an enforced axial flow. Phys. Fluids 23, 114108.CrossRefGoogle Scholar
Imayama, S.2012 Experimental study of the rotating-disk boundary-layer flow. Licentiate thesis, Royal Institute of Technology, KTH Mechanics.Google Scholar
Imayama, S., Alfredsson, P. H. & Lingwood, R. J. 2013 An experimental study of edge effects on rotating-disk transition. J. Fluid Mech. 716, 638657.CrossRefGoogle Scholar
Imayama, S., Alfredsson, P. H. & Lingwood, R. J. 2014a On the laminar-turbulent transition of the rotating-disk flow – the role of absolute instability. J. Fluid Mech. 745, 132163.CrossRefGoogle Scholar
Imayama, S., Lingwood, R. J. & Alfredsson, P. H. 2014b The turbulent rotating-disk boundary layer. Eur. J. Mech. (B/Fluids) 48, 245253.CrossRefGoogle Scholar
von Kármán, T. 1921 Über laminare und turbulente Reibung. Z. Angew. Math. Mech. 1, 232252.Google Scholar
Kobayashi, R., Kohama, Y. & Takamadate, C. 1980 Spiral vortices in boundary layer transition regime on a rotating disk. Acta Mechanica 35, 7182.CrossRefGoogle Scholar
Lingwood, R. J. 1995 Absolute instability of the boundary layer on a rotating disk. J. Fluid Mech. 299, 1733.CrossRefGoogle Scholar
Lingwood, R. J. & Alfredsson, P. H. 2015 Instabilities of the von Kármán boundary layer. Appl. Mech. Rev. 67, 030803.CrossRefGoogle Scholar
Malik, M. R., Li, F., Choudhari, M. M. & Chang, C.-L. 1999 Secondary instability of crossflow vortices and swept-wing boundary-layer transition. J. Fluid Mech. 399, 85115.CrossRefGoogle Scholar
Malik, M. R., Wilkinson, S. P. & Orszag, S. A. 1981 Instability and transition in rotating disk flow. AIAA J. 19, 11311138.CrossRefGoogle Scholar
Oh, I.-R., Kim, M.-K., Jo, Y.-W., Kim, D.-H., Choi, Y.-D., Moon, Y.-J. & Chung, J.-T. 2012 Study on the reduction of flow-induced noise through the suppression of vortex shedding at rotating disk edge. J. Mech. Sci. Technol. 26, 38333841.CrossRefGoogle Scholar
Pier, B. 2003 Finite-amplitude crossflow vortices, secondary instability and transition in the rotating-disk boundary layer. J. Fluid Mech. 487, 315343.CrossRefGoogle Scholar
Pier, B. 2007 Primary crossflow vortices, secondary absolute instabilities and their control in the rotating-disk boundary layer. J. Engng Maths 57, 237251.CrossRefGoogle Scholar
Saric, W. S., Carrillo, R. B. & Reibert, M. S.1998 Leading-edge roughness as a transition control mechanism. AIAA Paper 98–0781.CrossRefGoogle Scholar
Serre, E., Tuliszka-Sznitko, E. & Bontoux, P. 2004 Coupled numerical and theoretical study of the flow transition between a rotating and a stationary disk. Phys. Fluids 16, 688706.CrossRefGoogle Scholar
Thomas, C. & Davies, C. 2010 The effects of mass transfer on the global stability of the rotating-disk boundary layer. J. Fluid Mech. 663, 401433.CrossRefGoogle Scholar
Thomas, C. & Davies, C. 2013 Global stability of the rotating-disc boundary layer with an axial magnetic field. J. Fluid Mech. 724, 510526.CrossRefGoogle Scholar
Viaud, B., Serre, E. & Chomaz, J.-M. 2008 The elephant mode between two rotating disks. J. Fluid Mech. 598, 451464.CrossRefGoogle Scholar
Viaud, B., Serre, E. & Chomaz, J.-M. 2011 Transition to turbulence through steep global-modes cascade in an open rotating cavity. J. Fluid Mech. 688, 493506.CrossRefGoogle Scholar
Wassermann, P. & Kloker, M. 2002 Mechanisms and passive control of crossflow-vortex-induced transition in a three-dimensional boundary layer. J. Fluid Mech. 456, 4984.CrossRefGoogle Scholar
Wassermann, P. & Kloker, M. 2003 Transition mechanisms induced by travelling crossflow vortices in a three-dimensional boundary layer. J. Fluid Mech. 483, 6789.CrossRefGoogle Scholar
Wilkinson, S. & Malik, M. R. 1985 Stability experiments in the flow over a rotating disk. AIAA J. 23, 588595.CrossRefGoogle Scholar
Yim, E., Chomaz, J.-M., Marinand, D. & Serre, E. 2017 Transition to turbulence in the rotating disk boundary layer of a rotor-stator cavity. J. Fluid Mech. (submitted).Google Scholar