Published online by Cambridge University Press: 29 May 2018
A random forcing approach was implemented into a high-order accurate finite-difference code in order to investigate ‘natural’ laminar–turbulent transition in hypersonic boundary layers. In hypersonic transition wind-tunnel experiments, transition is caused ‘naturally’, by free-stream disturbances even when so-called quiet tunnels are employed such as the Boeing/AFOSR Mach 6 Quiet Tunnel (BAM6QT) at Purdue University. The nature and composition of the free-stream disturbance environment in high-speed transition experiments is difficult to assess and therefore largely unknown. Consequently, in the direct numerical simulations (DNS) presented here, the free-stream disturbance environment is simply modelled by random pressure (acoustic) disturbances with a broad spectrum of frequencies and a wide range of azimuthal wavenumbers. Results of a high-resolution DNS for a flared cone at Mach 6, using the random forcing approach, are presented and compared to a fundamental breakdown simulation using a ‘controlled’ disturbance input (with a specified frequency and azimuthal wavenumber). The DNS results with random forcing clearly exhibit the ‘primary’ and ‘secondary’ streak pattern, which has previously been observed in our ‘controlled’ breakdown simulations and the experiments in the BAM6QT. In particular, the spanwise spacing of the ‘primary’ streaks for the random forcing case is identical to the spacing obtained from the ‘controlled’ fundamental breakdown simulation. A comparison of the wall pressure disturbance signals between the random forcing DNS and experimental data shows remarkable agreement. The random forcing approach seems to be a promising strategy to investigate nonlinear breakdown in hypersonic boundary layers without introducing any bias towards a distinct nonlinear breakdown mechanism and/or the selection of specific frequencies or wavenumbers that is required in the ‘controlled’ breakdown simulations.
To send this article to your Kindle, first ensure no-reply@cambridge.org is added to your Approved Personal Document E-mail List under your Personal Document Settings on the Manage Your Content and Devices page of your Amazon account. Then enter the ‘name’ part of your Kindle email address below. Find out more about sending to your Kindle. Find out more about saving to your Kindle.
Note you can select to save to either the @free.kindle.com or @kindle.com variations. ‘@free.kindle.com’ emails are free but can only be saved to your device when it is connected to wi-fi. ‘@kindle.com’ emails can be delivered even when you are not connected to wi-fi, but note that service fees apply.
Find out more about the Kindle Personal Document Service.
To save this article to your Dropbox account, please select one or more formats and confirm that you agree to abide by our usage policies. If this is the first time you used this feature, you will be asked to authorise Cambridge Core to connect with your Dropbox account. Find out more about saving content to Dropbox.
To save this article to your Google Drive account, please select one or more formats and confirm that you agree to abide by our usage policies. If this is the first time you used this feature, you will be asked to authorise Cambridge Core to connect with your Google Drive account. Find out more about saving content to Google Drive.