Article contents
A study of wall shear stress in turbulent channel flow with hemispherical roughness
Published online by Cambridge University Press: 20 December 2019
Abstract
Direct numerical simulations (DNS) of turbulent channel flow over hexagonally packed hemispheres were performed for friction Reynolds number $Re_{\unicode[STIX]{x1D70F}}=200{-}600$. For cases at $Re_{\unicode[STIX]{x1D70F}}=400$, the inner-scaled roughness height $k^{+}=20$ was maintained while the spacing between roughness elements was varied from $d/k=2$ to 4. Two additional rough-wall cases were performed at $Re_{\unicode[STIX]{x1D70F}}=200$ and $600$, where $k^{+}=20$ and $d/k=4$ were fixed to investigate the $Re$ trends. For each case, wall shear stress was extracted from DNS by integrating the stress tensor over the rough surfaces. Spherical harmonics were employed to investigate the detailed spectral behaviour of the wall shear stress. Flow visualization near roughness elements was used to assist physical interpretations of the dominant flow features observed for various roughness characteristics. Analysis of amplitude modulation was applied to investigate the interactions between the ‘cell-averaged’ wall shear stress and outer, large-scale structures. A universal signal was obtained by removing the effects of outer, large-scale motions, based on the model proposed by Mathis et al. (J. Fluid Mech., vol. 715, 2013, pp. 163–180). Pre-multiplied spectra of the universal wall shear stress showed distinct behaviours at smaller scales for the ‘k-type’ roughness ($d/k=3{-}4$) compared to ‘d-type’ roughness ($d/k=2$), whereas the spectra at larger scales appeared similar for both types of roughness. A scaling relation between the variance of universal wall shear stress and averaging cell dimensions was found for both ‘k-type’ and ‘d-type’ roughness, which can be useful in designing candidate wall models used in large-eddy simulation.
- Type
- JFM Papers
- Information
- Copyright
- © 2019 Cambridge University Press
References
- 18
- Cited by