Published online by Cambridge University Press: 20 April 2006
Unsteady separating turbulent boundary layers are of practical interest because of unsteady aerodynamic phenomena associated with blades in compressors and with helicopter rotors in translating motion during high-loading conditions. Extensive measurements of a steady free-stream, nominally two-dimensional, separating turbulent boundary layer have been reported by Simpson, Chew & Shivaprasad (1981a, b) and Shiloh, Shivaprasad & Simpson (1981). Here measurements are reported that show the effects of sinusoidal unsteadiness of the free-stream velocity on this separating turbulent boundary layer at a practical reduced frequency of 0·61. The ratio of oscillation amplitude to mean velocity is about 0·3.
Upstream of flow detachment, single- and cross-wire, hot-wire anemometer measurements were obtained. A surface hot-wire anemometer was used to measure the phase-averaged skin friction. Measurements in the detached-flow zone of phase-averaged velocities and turbulence quantities were obtained with a directionally sensitive laser anemometer. The fraction of time that the flow moves downstream was measured by the LDV and by a thermal flow-direction probe.
Upstream of any flow reversal or backflow, the flow behaves in a quasisteady manner, i.e. the phase-averaged flow is described by the steady free-stream flow structure. The semilogarithmic law-of-the-wall velocity profile applies at each phase of the cycle. The Perry & Schofield (1973) velocity-profile correlations fit the mean and ensemble-averaged velocity profiles near detachment.
After the beginning of detachment, large amplitude and phase variations develop through the flow. Unsteady effects produce hysteresis in relationships between flow parameters. As the free-stream velocity during a cycle begins to increase, the Reynolds shearing stresses increase, the detached shear layer decreases in thickness, and the fraction of time $\hat{\gamma}_{{\rm p}u}$ that the flow moves downstream increases as backflow fluid is washed downstream. As the free-stream velocity nears the maximum value in a cycle, the increasingly adverse pressure gradient causes progressively greater near-wall backflow at downstream locations, while $\hat{\gamma}_{{\rm p}u}$ remains high at the upstream part of the detached flow. After the free-stream velocity begins to decelerate, the detached shear layer grows in thickness and the location where flow reversal begins moves upstream. This cycle is repeated as the free-stream velocity again increases.
To send this article to your Kindle, first ensure no-reply@cambridge.org is added to your Approved Personal Document E-mail List under your Personal Document Settings on the Manage Your Content and Devices page of your Amazon account. Then enter the ‘name’ part of your Kindle email address below. Find out more about sending to your Kindle. Find out more about saving to your Kindle.
Note you can select to save to either the @free.kindle.com or @kindle.com variations. ‘@free.kindle.com’ emails are free but can only be saved to your device when it is connected to wi-fi. ‘@kindle.com’ emails can be delivered even when you are not connected to wi-fi, but note that service fees apply.
Find out more about the Kindle Personal Document Service.
To save this article to your Dropbox account, please select one or more formats and confirm that you agree to abide by our usage policies. If this is the first time you used this feature, you will be asked to authorise Cambridge Core to connect with your Dropbox account. Find out more about saving content to Dropbox.
To save this article to your Google Drive account, please select one or more formats and confirm that you agree to abide by our usage policies. If this is the first time you used this feature, you will be asked to authorise Cambridge Core to connect with your Google Drive account. Find out more about saving content to Google Drive.