Hostname: page-component-586b7cd67f-gb8f7 Total loading time: 0 Render date: 2024-12-03T00:27:57.120Z Has data issue: false hasContentIssue false

Reynolds stress distribution and turbulence generated secondary flow in the turbulent three-dimensional wall jet

Published online by Cambridge University Press:  13 July 2016

L. Namgyal*
Affiliation:
Department of Mechanical Engineering, University of New Brunswick, Fredericton, E3B 5A3, Canada
J. W. Hall
Affiliation:
Department of Mechanical Engineering, University of New Brunswick, Fredericton, E3B 5A3, Canada
*
Email address for correspondence: [email protected]

Abstract

The lateral half-width of the turbulent three-dimensional wall jet is typically five to eight times larger than the vertical half-width normal to the wall. Although the reason for this behaviour is not fully understood, it is caused by mean secondary flows that develop in the jet due to the presence of the wall. The origin of the secondary flow has been associated previously with both vorticity reorientation and also gradients in the Reynolds stresses, although this has not been directly quantified as yet. The present investigation focuses on a wall jet formed using a circular contoured nozzle with exit Reynolds number of 250 000. Stereoscopic particle image velocimetry measurements are used herein to measure the three-component velocity, thereby allowing access to the full Reynolds stress tensor that contributes to the secondary flow in a turbulent three-dimensional wall jet. Throughout the jet, the Reynolds normal stress ($\overline{u^{2}}$) makes the largest contribution to the Reynolds stress field whereas Reynolds shear stress ($\overline{vw}$) is found to be negligible when compared with other stresses. In particular, the differences in the Reynolds normal stresses ($\overline{v^{2}}-\overline{w^{2}}$) are found to be significantly larger than $\overline{vw}$; these terms are important for the generation of turbulence secondary flow in the wall jet. Above all, the differences in the Reynolds normal stresses are oriented to reinforce the near-wall streamwise vorticity, and thus contribute to the large lateral growth of this flow. The contours of the turbulent kinetic budget indicate that the turbulent energy budget obtained on the jet centreline is different from that obtained off of the jet centreline.

Type
Papers
Copyright
© 2016 Cambridge University Press 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Abrahamsson, H., Johansson, B. & Lofdahl, L.1997a An investigation of the turbulence field in the fully developed three-dimensional wall jet. Internal Rep. 97-1. Chalmers University of Technology, Sweden.Google Scholar
Abrahamsson, H., Johansson, B. & Lofdahl, L.1997b The turbulence field of a fully developed three-dimensional wall jet. Tech. Rep. 91-1. Chalmers University of Technology, Sweden.Google Scholar
Adane, K. F. K. & Tachie, M. F. 2010 Experimental and numerical study of laminar round jet flows along a wall. Trans. ASME J. Fluids Engng 132, 101203.Google Scholar
Agelinchaab, M. & Tachie, M. F. 2011 Characteristics of turbulent three-dimensional wall jets. J. Fluid Engng 133 (2), 021201.Google Scholar
Bradshaw, P. 1987 Turbulent secondary flow. Annu. Rev. Fluid Mech. 19, 5374.Google Scholar
Brundrett, E. & Baines, W. D. 1964 The production and diffusion of vorticity in duct flow. J. Fluid Mech. 19 (03), 375394.Google Scholar
Capp, S. P., Hussien, H. J. & George, W. K1990 Velocity measurements in a high Reynolds number, momentum-conserving, axisymmetric, turbulent jet. Tech. Rep. Turbulence Research Laboratory, University of Baffallo, SUNY.Google Scholar
Cooper, D., Jackson, D. C., Launder, B. E. & Liau, G. X. 1993 Impinging jet studies for turbulence model assessment. I: flow-field experiments. Intl J. Heat Mass Transfer 36, 26752684.Google Scholar
Craft, T. J. & Launder, B. E. 2001 On the spreading mechanism of the three-dimensional turbulent wall jet. J. Fluid Mech. 435, 305326.Google Scholar
Davis, M. R. & Winarto, H. 1980 Jet diffusion from a circular nozzle above a solid plane. J. Fluid Mech. 101, 193218.Google Scholar
Eriksson, J. G. & Karlsson, R. I. 2000 Near-wall turbulence structure in the plane turbulent wall jet in still surroundings. In 10th International Symposium on Applications of Laser Techniques to Fluid Mechanics, Lisbon, Portugal, Inst Superior Technico.Google Scholar
Eriksson, J. G., Karlsson, R. I. & Persson, J. 1998 An experimental study of a two-dimensional plane wall jet. Exp. Fluids 25, 5060.Google Scholar
Hall, J. W. & Ewing, D.2005a The rectangular wall jet. Part I: the effect of varying aspect ratio. In 43rd AIAA Aerospace Sciences Meeting and Exhibit, 10–13 Jan 2005, Reno, Nevada. AIAA Paper 2005-0115.Google Scholar
Hall, J. W. & Ewing, D.2005b The rectangular wall jet. Part II: role of the large-scale structures. In 43rd AIAA Aerospace Sciences Meeting and Exhibit, 10–13 Jan 2005, Reno, Nevada. AIAA Paper 2005-0116.Google Scholar
Hall, J. W. & Ewing, D.2006 A combined spatial and temporal decomposition of the coherent structures in the three-dimensional wall jet. In 44th AIAA Aerospace Sciences Meeting and Exhibit, 9–12 Jan 2006, Reno, Nevada. AIAA Paper 2006-308.Google Scholar
Hall, J. W. & Ewing, D. 2007a The asymmetry of the large-scale structures in turbulent three-dimensional wall jets exiting long rectangular channels. Trans. ASME J. Fluids Engng 129, 929941.Google Scholar
Hall, J. W. & Ewing, D. 2007b The development of three-dimensional turbulent wall jets issuing from moderate aspect ratio rectangular channels. AIAA J. 45 (6), 11771186.Google Scholar
Hall, J. W. & Ewing, D. 2010 Spectral linear stochastic estimation of the turbulent velocity in a square three-dimensional wall jet. Trans. ASME J. Fluids Engng 132 (5).Google Scholar
Hussein, H. J., Capp, S. P. & George, W. K. 1994 Velocity measurements in a high-Reynolds-number momentum-conserving axisymmetric turbulent jet. J. Fluid Mech. 258, 3175.Google Scholar
Launder, B. E. & Rodi, W. 1983 The turbulent wall jet – measurements and modelling. Annu. Rev. Fluid Mech. 15, 429459.Google Scholar
LaVision 2007 Product Manual – Flow Master. LaVision GmbH.Google Scholar
Mathieu, J. & Scott, J. 2000 An Introduction to Turbulent Flow. Cambridge University Press.Google Scholar
Matsuda, H., Iida, S. & Hayakawa, M. 1990 Coherent structures in three-dimensional wall jet. Trans. ASME J. Fluids Engng 112, 462467.Google Scholar
Namgyal, L.2012 Three-component particle image velocimetry measurements in a turbulent three-dimensional wall jet. PhD thesis, University of New Brunswick, Fredericton, New Brunswick, Canada.Google Scholar
Namgyal, L. & Hall, J. W. 2010 PIV measurements of the turbulent secondary flow in a three-dimensional wall jet. In Proceedings of ASME 2010 3rd Joint US–Engineering Summer Meeting and 8th International Conference on Nanochannels, Microchannels & Minichannels. Montreal, Canada, ASME, Paper Number FEDSM–ICNMM2010-30278.Google Scholar
Namgyal, L. & Hall, J. W. 2011 A POD investigation of the three-dimensional wall jet near field. In Seventh International Symposium on Turbulence and Shear Flow Phenomena (TSFP-7), Ottawa, Canada. Taylor & Francis.Google Scholar
Padmanabham, G. & Gowda, B. H. L. 1991a Mean and turbulence characteristics of a class of three-dimensional wall jets. Part 1: mean flow characteristics. Trans. ASME J. Fluids Engng 113, 620628.CrossRefGoogle Scholar
Padmanabham, G. & Gowda, B. H. L. 1991b Mean and turbulence characteristics of a class of three-dimensional wall jets. Part 2: turbulence characteristics. Trans. ASME J. Fluids Engng 113, 620628.Google Scholar
Panchapakesan, N. R. & Lumley, J. L. 1993 Turbulence measurement in axisymmetric jets of air and helium. Part 1: air jet. J. Fluid Mech. 246, 197223.Google Scholar
Quinn, W. R. 2005 Measurements in the near field of an isosceles triangular turbulent free jet. Experiments 39 (1), 111126.Google Scholar
Rajaratnam, N. & Pani, B. S. 1974 Three-dimensional turbulent wall jets. J. Hydraul. Div. ASCE 100, 6983.Google Scholar
Rostamy, N., Bergstrom, D. J., Sumner, D. & Bugg, J. D. 2011 The effect of surface roughness on the turbulence structure of a plane wall jet. Phys. Fluids 23 (8), 085103.Google Scholar
Sun, H.2002 The effect of initial conditions on the development of the three-dimensional wall jet. PhD thesis, McMaster University, Hamilton, Ontario, Canada.Google Scholar
Sun, H. & Ewing, D. 2002a Development of the large-scale structures in the intermediate region of the three-dimensional wall jet. In Proceedings of the Fluids Engineering Division Summer Meeting Montreal, New York, ASME, Paper Number FEDSM2002-31414.Google Scholar
Sun, H. & Ewing, D.2002b Effect of initial and boundary conditions on the development of three-dimensional wall jet. In Proceedings of the AIAA winter meeting, Tahoe.Google Scholar
Tachie, M. F.2000 Open channel turbulent boundary layers and wall jets on rough surfaces. PhD thesis, University of Saskatchewan.Google Scholar
Tinney, C. E., Glauser, M. N. & Ukeiley, L. S. 2008 Low-dimensional characteristics of a transonic jet. Part 1: proper orthogonal decomposition. J. Fluid Mech. 612, 107141.Google Scholar
Venas, B., Abrahamsson, H., Krogsad, P. A. & Lofdahl, L. 1999 Pulsed hot-wire measurements in two and three-dimensional wall jets. Exp. Fluids 27, 210218.Google Scholar
Whittaker, E. T. 1915 On the functions which are represented by the expansion of the interpolation-theory. Proc. R. Soc. Edin. 35, 181194.Google Scholar
Wygnanski, I. & Fiedler, H. 1969 Some measurements in the self-preserving jet. J. Fluid Mech. 38, 577612.Google Scholar
Xu, H. 2009 Direct numerical simulation of turbulence in a square duct. J. Fluid Mech. 621, 2357.Google Scholar