Hostname: page-component-cd9895bd7-mkpzs Total loading time: 0 Render date: 2024-12-18T20:46:05.500Z Has data issue: false hasContentIssue false

Instability of viscous axial flow in annuli having a rotating inner cylinder

Published online by Cambridge University Press:  12 April 2006

N. Gravas
Affiliation:
Department of Mechanical Engineering and Engineering Production, University of Wales Institute of Science and Technology, Cardiff
B. W. Martin
Affiliation:
Department of Mechanical Engineering and Engineering Production, University of Wales Institute of Science and Technology, Cardiff

Abstract

Hot-wire measurements are presented of the onset of instability in developed axial and tangential flow due to inner-cylinder rotation in annuli of radius ratios 0·9, 0·81 and 0·58 for axial-flow Reynolds numbers between 86 and 2000. Measurements of the minimum critical Taylor number are reported along three radii at azimuthal locations 90° apart. At the largest radius ratio these azimuthal measurements show considerable variation but the sensitivity of marginal stability to angular orientation becomes negligible at a radius ratio of 0·58, when measurements and the Galerkin predictions of Hasoon & Martin (1977) are in close accord. The greater sensitivity to orientation as the radius ratio increases appears to correlate with measured percentage circumferential variations in annulus width arising from manufacturing tolerances and non-uniform curvature of the surfaces.

Type
Research Article
Copyright
© 1978 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Astill, K. N. 1961 Ph.D. thesis, Massachusetts Institute of Technology.
Astill, K. N. 1964 Studies of the developing flow between concentric cylinders with the inner cylinder rotating. J. Heat Transfer, Trans. A.S.M.E. C 86, 383392.Google Scholar
Becker, K. M. & Kaye, J. 1962 Measurements of diabatic flow in an annulus with a rotating inner cylinder. J. Heat Transfer, Trans. A.S.M.E. C 84, 97105.Google Scholar
Chandrasekhar, S. 1960a The hydrodynamic stability of inviscid flow between co-axial cylinders. Proc. Nat. Acad. Sci. Wash. 46, 137141.Google Scholar
Chandrasehkar, S. 1960b The hydrodynamic stability of viscid flow between co-axial cylinders. Proc. Nat. Acad. Sci. Wash. 46, 141143.Google Scholar
Chung, K. C. & Astill, K. N. 1977 Hydrodynamic instability of viscous flow between rotating coaxial cylinders with fully developed axial flow. J. Fluid Mech. 81, 641655.Google Scholar
Diprima, R. C. 1960 The stability of a viscous fluid between rotating cylinders with an axial flow. J. Fluid Mech. 9, 621631.Google Scholar
Donnelly, R. J. & Fultz, D. 1960 Experiments on the stability of spiral flow between rotating cylinders. Proc. Nat. Acad. Sci. Wash. 46, 11501154.Google Scholar
Elliott, L. 1973 Stability of a viscous fluid between rotating cylinders with axial flow and pressure gradient round the cylinders. Phys. Fluids 16, 577580.Google Scholar
Gravas, N. 1976 M.Eng. thesis, University of Wales Institute of Science and Technology, Cardiff.
Hasoon, M. A. & Martin, B. W. 1977 The stability of viscous axial flow in an annulus with a rotating inner cylinder. Proc. Roy. Soc. A 352, 351380.Google Scholar
Hughes, T. H. & Reid, W. H. 1968 The stability of spiral flow between rotating cylinders. Phil. Trans. Roy. Soc. A 263, 5791.Google Scholar
Kaye, J. & Elgar, E. C. 1958 Modes of adiabatic and diabatic fluid flow in an annulus with an inner rotating cylinder. Trans. A.S.M.E. 80, 753765.Google Scholar
Martin, B. W. & Payne, A. 1972 Tangential flow development for laminar axial flow in an annulus with a rotating inner cylinder. Proc. Roy. Soc. A 328, 123141.Google Scholar
Snyder, H. A. 1962 Experiments on the stability of spiral flow at low axial Reynolds numbers. Proc. Roy. Soc. A 265, 198214.Google Scholar
Sparrow, E. M. & Lin, S. H. 1964 The developing laminar flow and pressure drop in the entrance region of annular ducts. J. Basic Engng, Trans. A.S.M.E. D 86, 827834.Google Scholar