Article contents
Electrical conductivity of low-pressure shock-ionized argon
Published online by Cambridge University Press: 28 March 2006
Abstract
The electrical conductivity of shock-ionized argon produced in an electromagnetic shock tube of low attenuation has been measured at shock speeds of March 10–33, with initial pressures of 0·01–2·0 mm Hg. These measurements extend considerably the range of previous measurements performed with pressure-driven shock tubes. With the higher initial pressures or at the highest Mach numbers the measured conductivity is in good agreement with the previous measurements and with the Spitzer–Harm (1953) formula for the conductivity of a fully ionized gas. With the lower initial pressures (which have not previously been investigated) and at the lower March numbers the conductivity falls to less than half of the Spitzer-Harm value. Order-of-magnitude calculations show that diffusion of atoms, and heat conduction by the plasma atoms from the plasma to the shock-tube walls, can cause appreciable plasma cooling (and hence a reduction of the electrical conductivity) with the lowest initial pressures. This mechanism in conjunction with non-attainment of equilibrium ionization appears to explain the observed diminution in conductivity at the lowest pressures, but not the reduced conductivity at the medium pressures.
Induced e.m.f. flow-velocity measurements indicate steady-flow conditions in the shock tube while photomultiplier measurements of the plasma radiation indicate that the column of shock-heated gas is 10–20 cm long; this latter figure is supported by the conductivity measurements. The fact that the length of the shock-heated gas column is not drastically shortened at low initial pressures in constrast to the work of Duff (1959), Roshko (1960) and Hooker (1961) is attributed to the fact that in this experiment both driver and driven gases are at high temperature.
- Type
- Research Article
- Information
- Copyright
- © 1963 Cambridge University Press
References
- 6
- Cited by