Hostname: page-component-cd9895bd7-jn8rn Total loading time: 0 Render date: 2024-12-27T04:41:15.587Z Has data issue: false hasContentIssue false
  • English
  • Français

An experimental investigation of an incompressible turbulent boundary layer in the vicinity of separation

Published online by Cambridge University Press:  26 April 2006

P. Dengel  and
H. H. Fernholz
P. Dengel
Affiliation:
Hermann-Föttinger-Institut, Technische Universität Berlin, Strasse des 17 Juni 135, D-1000 Berlin 12
H. H. Fernholz
Affiliation:
Hermann-Föttinger-Institut, Technische Universität Berlin, Strasse des 17 Juni 135, D-1000 Berlin 12
Get access Rights & Permissions [Opens in a new window]

Abstract

The following is an investigation into the effects of small changes in the static pressure distribution on the development of an axisymmetric, incompressible, turbulent boundary layer with incipient separation. The pressure distribution was closely controlled to study three cases, in which the skin friction was either approximately zero, slightly negative, or slightly positive along a fixed length. Mean flow and turbulence structure in air were measured using pulsed-wire and hot-wire anemometry.

These measurements show characteristic properties of steady turbulent boundary layers both on the verge of separation and with a long, shallow separation bubble. There is an asymptotic velocity defect law near separation. A linear relationship between χW, the wall value of the reverse-flow parameter, and the form parameter H12 suggests the importance of χW in characterizing the boundary layer. The occurrence of the first reverse-flow events coincides with the vanishing of the logarithmic law, the asymptotic mean velocity profile, and a sudden drop in the values of the skewness SW and the flatness FW of the skin friction. This implies that the presence of instantaneous reverse flow is associated with a complete change in the nature of the near-wall flow, well upstream of mean separation. As the three cases were investigated in a single test section under closely controlled conditions with the same experimental techniques, this data set is well suited to a sensitivity study. It is possible to show the effect of small changes in the upstream pressure gradient on the separation region and to distinguish the effect of mean reverse flow from that of the adverse pressure gradient. This effect of the reverse flow is displayed most clearly in a plateau in $\overline{u^{\prime 2}}$ near the wall and in unusual behaviour of the skewness and the flatness profiles over the inner half of the boundary layer.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 212 , March 1990 , pp. 615 - 636
Copyright
© 1990 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Andreopoulos, J., Durst, F., Zaric, Z. & Jovanovic, J., 1984 Influence of Reynolds number on characteristics of turbulent wall boundary layers. Exps Fluids 2, 7–16.Google Scholar
Coles, D.: 1956 The law of the wake in the turbulent boundary layer. J. Fluid Mech. 1, 191–226.Google Scholar
Dengel, P.: 1989 Über die Struktur und Sensibilität einer inkompressiblen turbulenten Grenzschicht am Rande der Ablösung. Eingereicht als Dissertation am FB 9 der Technischen Universität Berlin.
Dengel, P. & Fernholz, H. H., 1989 Generation of and measurements in a turbulent boundary layer with zero skin friction. Proc. 2nd European Turbulence Conf., Berlin. Springer.
Dengel, P., Fernholz, H. H. & Hess, M., 1987 Skin-friction measurements in two- and three-dimensional highly turbulent flows with separation. Proc. 1st European Turbulence Conf., Lyon. Springer.
Dengel, P., Fernholz, H. H. & Vagt, J.-D. 1982 Turbulent and mean flow measurements in an incompressible axisymmetric boundary layer with separation. Proc. 3rd Int. Symp. on Turbulent Shear Flows. Davies (ed. L. J. S. Bradbury et al.). Springer.
East, L. F., Nash, C. R., Sawyer, W. G.: 1979 An investigation of the structure of equilibrium turbulent boundary layers. RAE Tech. Rep. 79040.Google Scholar
Fernholz, H. H.: 1966 Eine grenzschichttheoretische Untersuchung optimaler Unterschalldiffusoren. Ing.-Arch. 35, 192–201.Google Scholar
Fernholz, H. H.: 1968 Experimentelle Untersuchung einer inkompressiblen turbulenten Grenzschicht mit Wandreibung nahe Null an einem längsangeströmten Kreiszylinder. Z. Flugwiss. 16, 402–406.Google Scholar
Fernholz, H. H. & Vagt, J.-D. 1977 Measurements in an axisymmetric turbulent boundary layer with weak and strong three-dimensional disturbances. In Structure and Mechanics of Turbulence 1. Lecture Notes in Physics, vol. 75 (ed. H. Fiedler), pp. 222–223. Springer.
Johansson, A. V. & Alfredsson, P. H., 1982 On the structure of turbulent channel flow. J. Fluid Mech. 122, 295–314.Google Scholar
Patrick, W. P.: 1987 Flowfield measurements in a separated and reattached flat plate turbulent boundary layer. NASA CR-4052.Google Scholar
Perry, A. & Schofield, W. H., 1973 Mean velocity and shear stress distributions in turbulent boundary layers. Phys. Fluids 16, 2068–2074.Google Scholar
Prandtl, L.: 1935 The mechanics of viscous fluids. In Aerodynamic Theory III (ed. W. F. Durand), pp. 34–208. Springer (see also H. Schlichting, Grenzschichttheorie 1964, pp. 200–202).
Rotta, J.: 1962 Turbulent boundary layers in incompressible flow. In Progress in Aeronautical Sciences (ed. Küchemann, et al.), vol. 2, pp. 1–219. Pergamon.
Schofield, W. H.: 1986 Two-dimensional separating turbulent boundary layers. AIAA J. 24, 1611–1620.Google Scholar
Shiloh, K., Shivaprasad, B. G. & Simpson, R. L., 1981 The structure of a separating turbulent boundary layer. Part 3. Transverse velocity measurements. J. Fluid Mech. 113, 17–90.Google Scholar
Simpson, R. L., Chew, Y.-T. & Shivaprasad, B. G. 1981a The structure of a separating turbulent boundary layer. Part 1. Mean flow and Reynolds stresses. J. Fluid Mech. 113, 23–51.Google Scholar
Simpson, R. L., Chew, Y.-T. & Shivaprasad, B. G. 1981b The structure of a separating turbulent boundary layer. Part 2. Higher-order turbulence results. J. Fluid Mech. 113, 53–73.Google Scholar
Simpson, R. L., Strickland, J. H. & Barr, P. W., 1977 Features of a separating turbulent boundary layer in the vicinity of separation. J. Fluid Mech. 79, 553–594.Google Scholar
Spangenberg, W. G., Rowland, W. R. & Mease, N. E., 1967 Measurements in a turbulent boundary layer maintained in a nearly separating condition. In Fluid Mechanics of Internal Flow (ed. G. Sovran), pp. 110–151. Elsevier.
Stratford, B. S.: 1959 An experimental flow with zero skin friction throughout its region of pressure rise. J. Fluid Mech. 5, 17–36.Google Scholar
Thompson, B. E. & Whitelaw, J. H., 1985 Characteristics of a trailing-edge flow with turbulent boundary-layer separation. J. Fluid Mech. 157, 305–326.Google Scholar
Vagt, J. D. & Fernholz, H. H., 1979 A discussion of probe effects and improved measuring techniques in the near wall region of an incompressible three-dimensional turbulent boundary layer. AGARD CP 271.Google Scholar
Wadcock, A. J.: 1979 Structure of the turbulent separated flow around a stalled air foil. NASA CR-152263.Google Scholar
Wadcock, A. J.: 1985 Investigation of low-speed turbulent separated flow around airfoils. NASA CR 177 450.Google Scholar