Hostname: page-component-cd9895bd7-8ctnn Total loading time: 0 Render date: 2024-12-19T00:15:53.105Z Has data issue: false hasContentIssue false
  • English
  • Français

The influence of hole dimensions on static pressure measurements

Published online by Cambridge University Press:  28 March 2006

R. Shaw
R. Shaw
Affiliation:
Department of Mechanical Engineering, University of Liverpool
Get access Rights & Permissions [Opens in a new window]

Abstract

The pressure measured at a static pressure hole differs slightly from the true static pressure, by an amount which depends on the hole size and shape. The present investigation extends the range of previous work to determine the error in static pressure measurement in incompressible turbulent flow. The observed static pressure was always greater than the true static pressure. The results are presented in dimesionless form as a function of the Reynolds number based on hole diameter and friction velocity.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 7 , Issue 4 , April 1960 , pp. 550 - 564
Copyright
© 1960 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Allen, C. M. & Hooper, L. J. 1932 Piezometer investigations. Trans. A.S.M.E. 54, HYD 54-1.Google Scholar
Fuhrmann, G. 1912 Theoretische und Experimentelle Untersuchungen an Ballonmodellen. Dissertation, Göttingen.
Myadzu, A. 1936 Influence of type and dimensions of pressure hole on the recorded static pressure. Ingen.-Arch. 7, 35.Google Scholar
Preston, J. H. 1950 The 3/4 radius Pitot tube flow meter. Engineer, 27 October, p. 400.Google Scholar
Preston, J. H. 1958 The minimum Reynolds number for a turbulent boundary layer and the selection of a transition device. J. Fluid Mech. 3, 373.Google Scholar
Ray, A. K. 1956 On the effect of orifice size on static pressure reading at different Reynolds numbers. Ingen.-Arch. 24 (3), 171. Translation in A.R.C. Rep. no. T.P. 498.Google Scholar
Rayle, R. E. Jr. 1949 An investigation of the influence of orifice geometry on static pressure measurements. M.S. Thesis, M.I.T.
Shaw, R. 1958 The measurement of static pressure. Report Advisory Group for Aeronautical Research and Development, no. 163, p. 1.Google Scholar
Thom, A. & Apelt, C. J. 1957 The pressure in a two-dimensional static hole at low Reynolds numbers. A.R.C. Rep. R. & M. no. 3090.Google Scholar