Hostname: page-component-cd9895bd7-gvvz8 Total loading time: 0 Render date: 2024-12-19T10:48:17.072Z Has data issue: false hasContentIssue false
  • English
  • Français

Buoyancy force reversals in vertical natural convection flows in cold water

Published online by Cambridge University Press:  19 April 2006

Van P. Carey ,
Benjamin Gebhart  and
Joseph C. Mollendorf
Van P. Carey
Affiliation:
Department of Mechanical Engineering, State University of New York at Buffalo, Amherst, New York 14260
Benjamin Gebhart
Affiliation:
Department of Mechanical Engineering, State University of New York at Buffalo, Amherst, New York 14260
Joseph C. Mollendorf
Affiliation:
Department of Mechanical Engineering, State University of New York at Buffalo, Amherst, New York 14260
Get access Rights & Permissions [Opens in a new window]

Abstract

Calculated numerical results are presented for laminar buoyancy-induced flows driven by thermal transport to or from a vertical isothermal surface in cold pure and saline water wherein a density extremum arises. The present calculations specifically explore the consequences of temperature conditions wherein the buoyancy force reverses across the thermal region owing to the presence of a density extremum within the region. Such conditions commonly occur in terrestrial waters and in technological processes utilizing cold water. The linear approximation of density dependence on temperature, used in conventional analysis, is here replaced by a very accurate non-linear density equation of state for both pure and saline water. This permits an accurate treatment of such flows for bounding temperatures up to 20 °C at ambient salinity and pressure levels from 0 to 40 p.p.t. and 1 to 1000 bars, respectively. The results may be applied to the melting or slow freezing of a vertical ice surface in pure water as well as to a heated or cooled vertical isothermal surface in pure or saline water. For example, buoyancy force reversals arise for a vertical ice surface at 0 °C melting in fresh water between 4 °C and 8 °C at atmospheric pressure. Temperature conditions for which buoyancy force reversals occur are of special interest because of the resulting anomalous flow behaviour and low surface heat-transfer rates. The transition from conditions with no buoyancy-force reversal to those resulting in a large buoyancy-force reversal is accompanied by as much as 50% decrease in surface heat transfer. This produces a corresponding trend in the melt rate of a vertical ice surface in pure water. Sufficiently strong buoyancy force reversals are found to cause local flow reversal either at the edge of the flow layer or near the surface. Conditions are determined for which flow reversals occur at each of these locations. These local flow reversals are the precursors of convective inversion, that is, of the reversal of the net flow direction with changing ambient medium temperature. Limits on conditions for convective inversion are determined. Calculated transport is compared with previous experimental results, with good agreement throughout the several regions of such complicated flows. The calculations indicate that such flows are relatively very weak. However, their form may lead to early laminar instability.

Type
Research Article
Information
Journal of Fluid Mechanics , Volume 97 , Issue 2 , 25 March 1980 , pp. 279 - 297
Copyright
© 1980 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Bendell, M. S. & Gebhart, B. 1976 Heat transfer and ice-melting in ambient water near its density extremum. Int. J. Heat & Mass Transfer 19, 1081–1087.Google Scholar
Caldwell, D. R. 1980 The maximum density points of saline water. Submitted to Deep-Sea Res.
Chen, C. T. & Millero, F. J. 1976 The specific volume of sea water at high pressures. Deep Sea Res. 23, 595–612.Google Scholar
Fine, R. A. & Millero, F. J. 1973 Compressibility of water as a function of temperature and pressure. J. Chem. Phys. 59, 5529–5536.Google Scholar
Gebhart, B., Carey, V. P. & Mollendorf, J. C. 1980 Buoyancy induced flows due to energy sources in cold quiescent pure and saline water. Chem. Engng Trans. (to appear).Google Scholar
Gebhart, B. & Mollendorf, J. C. 1977 A new density relation for pure and saline water. Deep Sea Res. 24, 813–848.Google Scholar
Gebhart, B. & Mollendorf, J. C. 1978 Buoyancy-induced flows in water under conditions in which density extrema may arise. J. Fluid Mech. 89, 673–707.Google Scholar
Johnson, R. S. & Mollendorf, J. C. 1980 Transport from a vertical pure water ice surface melting in saline water. In preparation.
Mollendorf, J. C., Johnson, R. S. & Gebhart, B. 1980 Several constant buoyancy plume flows in cold pure and saline water. Submitted to J. Fluid Mech.Google Scholar
Mollendorf, J. C., Kukulea, D. & Gebhart, B. 1980 Transport properties of seawater. In preparation.
Qureshi, Z. H. & Gebhart, B. 1978 Vertical natural convection with a uniform flux condition in pure and saline water at the density extremum. Proc. 6th Int. Heat Transfer Conf., Toronto.