Hostname: page-component-cd9895bd7-gbm5v Total loading time: 0 Render date: 2024-12-25T05:37:43.446Z Has data issue: false hasContentIssue false
  • English
  • Français

A comparison between a method of jointing meat carcasses based upon their anatomical structure and a method based upon standardized butchering practice: II. Comparison of the uniformity of results

Published online by Cambridge University Press:  27 March 2009

D. R. Williams
D. R. Williams
Affiliation:
Meat Research Institute, Agricultural Research Council, Langford, Near Bristol
Get access Rights & Permissions [Opens in a new window]

Summary

A standardized butcher-type method (B) in which anatomical reference points were used to determine cutting lines was compared with a semi-anatomical method (A) in which the jointing was based still more closely upon the anatomy of meat animals. Thirty-two lamb carcasses were split by hand sawing and the sides prepared for quartering, quartered and finally jointed into five hindquarter and five forequarter joints by one or other of two operators by either method A or method B according to a pre-arranged plan. Operator bias in the preparation of the sides for quartering was only noteworthy for the removal of internal fats.

Method A proved to be more consistent than method B, but the degree of advantage varied for different joints. In terms of the coefficients of variation for different joints by the two methods, method A had an advantage in consistency over method B for eight of the ten joints into which each side was divided.

The reproducibility of the semi-anatomical method (A) could be further improved by adopting more fully anatomical methods of joining.

The application and implications of an anatomical method in the excision of sample joints is noted.

Type
Research Article
Information
The Journal of Agricultural Science , Volume 71 , Issue 3 , December 1968 , pp. 425 - 430
Copyright
Copyright © Cambridge University Press 1968

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Bodwell, C. E. (1959). The use of linear measurements in evaluating beef carcasses. M.Sc. thesis, University of Cambridge.Google Scholar
Butterfield, R. M. (1963). A study of the musculature of the steer carcass. Ph.D. Thesis, University of Queensland.Google Scholar
Pomeroy, R. W. (1965). Standardized cutting of beef carcasses and sample joint dissection. A.R.C. Carcass Quality Studies Group—Subgroup on sheep and cattle, 07, 1965.Google Scholar
European Association for Animal Production (1953). Proc. of 3rd Study Meeting of E.A.A.P. Siena, Rome, Sept. 1953.Google Scholar
Walker, D. E. (1963). Age changes in the carcass composition of A.A. steers. Tech. Conf. on Carcass Composition and Appraisal in Meat Animals. Melbourne, 1963.Google Scholar