Hostname: page-component-cd9895bd7-gbm5v Total loading time: 0 Render date: 2024-12-28T12:37:27.454Z Has data issue: false hasContentIssue false
  • English
  • Français

A novel balanced-to-balanced power divider based on three-line coupled structure

Published online by Cambridge University Press:  14 January 2019

Zhen Tan ,
Qing-Yuan Lu  and
Jian-Xin Chen Open the ORCID record for Jian-Xin Chen [Opens in a new window]
Zhen Tan
Affiliation:
School of Electronics and Information, and Tongke School of Microelectronics, Nantong University, 9 Seyuan Road, Nantong 226019, China
Qing-Yuan Lu
Affiliation:
School of Electronics and Information, and Tongke School of Microelectronics, Nantong University, 9 Seyuan Road, Nantong 226019, China
Jian-Xin Chen*
Affiliation:
School of Electronics and Information, and Tongke School of Microelectronics, Nantong University, 9 Seyuan Road, Nantong 226019, China
*
Author for correspondence: Jian-Xin Chen, E-mail: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

This paper presents a novel balanced-to-balanced power divider (PD) based on a simple and compact three-line coupled structure for the first time. By bisecting the proposed symmetrical structure, the differential mode (DM) and the common mode (CM) equivalent circuits can be obtained for analysis. The DM equivalent circuit exhibits a three-line in-phase power dividing response, and then a resistor is added between the two outputs for achieving good isolation. Meanwhile, the CM equivalent circuit shows a three-line all-stop response so that the CM suppression in this design does not need to be considered. Accordingly, the detailed design procedure of the DM PD is given. For demonstration, a prototype centered at 1.95 GHz is designed, fabricated, and measured. The simulated and measured results with good agreement are presented, showing low DM loss and wideband CM suppression.

Keywords

Balanced-to-balanced power divider (PD)three-line coupled structurecommon-mode (CM) suppression
Type
Research Papers
Information
International Journal of Microwave and Wireless Technologies , Volume 11 , Issue 2 , March 2019 , pp. 139 - 142
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2019 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1.Woestenburg, EEM (2011) Noise properties of balanced amplifier configurations. International Journal of Microwave and Wireless Technologies 3, 67–75.Google Scholar
2.Feng, LP and Zhu, L (2018) Balun bandpass filter on slot-line resonators with intrinsic balanced performance in amplitude and phase. International Journal of Microwave and Wireless Technologies 10, 891–895.Google Scholar
3.Contreras, S and Peden, A (2013) Graphical design method for unequal power dividers based on phase-balanced SIW tee-junctions. International Journal of Microwave and Wireless Technologies 5, 603–610.Google Scholar
4.Xia, B, Wu, LS and Mao, JF (2012) A new balanced-to-balanced power divider/combiner. IEEE Transactions on Microwave Theory and Techniques 60, 2791–2798.Google Scholar
5.Xia, B, Wu, LS, Ren, SW and Mao, JF (2013) A balanced-to-balanced power divider with arbitrary power division. IEEE Transactions on Microwave Theory and Techniques 61, 2831–2840.Google Scholar
6.Shi, J and Xu, K (2014) Compact differential power divider with enhanced bandwidth and in-phase or out-of-phase output ports. Electronics Letters 50, 1209–1211.Google Scholar
7.Shi, J, Wang, J, Xu, K, Chen, JX and Liu, W (2015) A balanced-to-balanced power divider with wide bandwidth. IEEE Transactions on Microwave Theory and Techniques 25, 573–575.Google Scholar
8.Marchand, N (1944) Transmission line conversion transformers. Electronics 17, 142–145.Google Scholar
9.Ang, KS and Robertson, ID (2001) Analysis and design of impedance-transforming planar Marchand baluns. IEEE Transactions on Microwave Theory and Techniques 49, 402–406.Google Scholar
10.Pozar, DM (2009) Microwave Engineering. Hoboken, NJ: John Wiley and Sons.Google Scholar
11.Pavlidis, D and Hartnagel, HL (1976) The design and performance of three-line microstrip couplers. IEEE Transactions on Microwave Theory and Techniques 24, 631–640.Google Scholar
12.Abbosh, AM (2011) Three-way parallel-coupled microstrip power divider with ultrawideband performance and equal-power outputs. IEEE Microwave and Wireless Components Letters 21, 649–651.Google Scholar
13.Guo, L, Zhu, H and Abbosh, AM (2016) Wideband tunable in-phase power divider using three-line coupled structure. IEEE Microwave and Wireless Components Letters 26, 404–406.Google Scholar