Hostname: page-component-cd9895bd7-8ctnn Total loading time: 0 Render date: 2024-12-18T17:41:12.172Z Has data issue: false hasContentIssue false
  • English
  • Français

Design of wideband orthogonal MIMO antenna with improved correlation using a parasitic element for mobile handsets

Published online by Cambridge University Press:  15 September 2014

Ali Akdagli  and
Abdurrahim Toktas Open the ORCID record for Abdurrahim Toktas [Opens in a new window]
Ali Akdagli*
Affiliation:
Department of Electrical – Electronics Engineering, Faculty of Engineering, Mersin University, Ciftlikkoy, Yenisehir, 33343, Mersin, Turkey. Phone: +90 324 361 00 01/7056
Abdurrahim Toktas
Affiliation:
Department of Information Technologies, Mersin University, Ciftlikkoy, Yenisehir 33343, Mersin, Turkey
*
Corresponding author: A. Akdagli Email: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

In this paper, a novel design of compact wideband multiple-input multiple-output (MIMO) antenna operating over a frequency range of 1.8–4.0 GHz at 10 dB is presented for mobile terminals. The MIMO antenna design consists of two symmetrical and orthogonal radiating elements with a small size of 15.5 × 16.5 mm2 printed on the corners of a mobile circuit board. The radiating element is composed of four meandered monopole branches with a strip-line fed by a probe. By triangularly trimming the corners of the common ground plane beneath the radiating elements, not only the mutual coupling is reduced, but also impedance bandwidth is increased. Although, the antenna in this form has sufficient correlation level between the radiating elements for MIMO operation, a novel design of plus-shaped parasitic element is inserted to the ground plane between those radiating elements in order to further enhance the isolation. The performance of the MIMO antenna is investigated in terms of s-parameters, radiation pattern, gain, envelope correlation coefficient (ECC), and total active reflection coefficient (TARC), and is verified through the measurements. The results demonstrate that the proposed MIMO antenna has good characteristics of wideband, isolation, gain, radiation pattern, and is compatible with LTE, WiMAX, and WLAN, besides it is small, compact, and embeddable in mobile terminals.

Keywords

Antenna designModeling and measurementsSmart antennasDigital beam formingWidebandMIMOLTEWiMAXWLANMobile handset
Type
Research Papers
Information
International Journal of Microwave and Wireless Technologies , Volume 8 , Issue 1 , February 2016 , pp. 109 - 115
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2014 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1]Kuhn, V.: Wireless communications over MIMO channels: Applications to CDMA and multiple antenna systems, John Wiley & Sons, Chichester, England, 2006.Google Scholar
[2]Foschini, G.: Layered space-time architecture for wireless communication in a fading environment when using multi-element antennas. Bell Labs Tech. J., 1 (2) (1996), 41–59.Google Scholar
[3]Alamouti, S.: A simple transmit diversity technique for wireless communications. IEEE J. Sel. Area Commun., 16 (8) (1998), 451–458.Google Scholar
[4]Mallahzadeh, A.R.; Es'haghi, S.; Alipour, A.: Design of an E-shaped MIMO antenna using IWO algorithm for wireless application at 5.8 GHz. Prog. Electromagn. Res., 90 (2009), 187–203.Google Scholar
[5]Zhengyi, L.; Zhengwei, D.; Takahashi, M.; Saito, K.; Ito, K.: Reducing mutual coupling of MIMO antennas with parasitic elements for mobile terminals. IEEE Trans. Antennas Propag., 60 (2) (2012), 473–481.Google Scholar
[6]Toktas, A.; Akdagli, A.: Wideband MIMO antenna with enhanced isolation for LTE, WiMAX and WLAN mobile handsets. Electron. Lett., 50 (10) (2014), 723–724.Google Scholar
[7]Dai, X.-W.; Li, L.; Wang, Z.-Y.; Liang, C.-H.: High isolation and compact MIMO antenna system with defected shorting wall. Int. J. Microw. Wirel. Tech., FirstView (2014), 1–6.Google Scholar
[8]Zhang, S.; Lau, K.B.; Tan, Y.; Ying, Z.; He, S.: Mutual coupling reduction of two PIFAs with a T-shape slot impedance transformer for MIMO mobile terminals. IEEE Trans. Antennas Propag., 60 (3) (2012), 1521–153.Google Scholar
[9]Ling, X.; Li, R.: A novel dual-band MIMO antenna array with low mutual coupling for portable wireless devices. IEEE Antennas Wirel. Propag. Lett., 10 (2011), 1039–1042.Google Scholar
[10]Li, J.-F.; Chu, Q.-X.; Huang, T.-G.: A compact wideband MIMO antenna with two novel bent slits. IEEE Trans. Antennas Propag., 60 (2) (2012), 482–489.Google Scholar
[11]Sharawi, M.S.; Numan, A.B.; Khan, M.U.; Aloi, D.N.: A dual-element dualband MIMO Antenna system with enhanced isolation for mobile terminals. IEEE Antennas Wirel. Propag. Lett., 11 (2012), 1006–1009.CrossRefGoogle Scholar
[12]Rao, Q.; Wilson, K.: Design, modeling, and evaluation of a multiband MIMO/Diversity antenna system for small wireless mobile terminals. IEEE Trans. Compon. Packag. Manufact. Technol., 1 (3) (2011), 410–419.CrossRefGoogle Scholar
[13]Shoaib, S.; Shoaib, I.; Shoaib, N.; Chen, X.; Parini, C.G.: Design and performance study of a dual-element multiband printed monopole antenna array for MIMO terminals. IEEE Antennas Wirel. Propag. Lett., 13 (2014), 329–332.Google Scholar
[14]Ibrahim, A.A.; Abdalla, M.A.; Abdel-Rahman, A.B.; Hamed, H.F.A.: Compact MIMO antenna with optimized mutual coupling reduction using DGS. Int. J. Microw. Wirel. Technol., 6 (2014), 173–180.CrossRefGoogle Scholar
[15]IE3D™, version 14, Menthor graphics corporation, Boeckman Road Wilsonville, OR 9707.Google Scholar