Hostname: page-component-cd9895bd7-q99xh Total loading time: 0 Render date: 2024-12-18T17:06:34.197Z Has data issue: false hasContentIssue false
  • English
  • Français

Design of center-fed printed planar slot arrays

Published online by Cambridge University Press:  09 December 2015

L. Potgieter ,
J. Joubert  and
J. W. Odendaal
L. Potgieter*
Affiliation:
Department of Electrical, Electronic and Computer Engineering, University of Pretoria, Pretoria 0002, South Africa. Phone: +27 12 674 3560
J. Joubert
Affiliation:
Department of Electrical, Electronic and Computer Engineering, University of Pretoria, Pretoria 0002, South Africa. Phone: +27 12 674 3560
J. W. Odendaal
Affiliation:
Department of Electrical, Electronic and Computer Engineering, University of Pretoria, Pretoria 0002, South Africa. Phone: +27 12 674 3560
*
Corresponding author: L. Potgieter Email: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

A design approach for printed planar slot array antennas is presented. The antenna array consists of half-wavelength slot radiators positioned on a rectangular grid, and a slotline feed network. Three planar slot array antennas for use in IEEE 802.11a applications are designed, a 2 × 2, a 2 × 4, and a 4 × 2 array, all radiating above an electric conductor ground plane placed a quarter-wavelength below the printed slots. These slot arrays have higher aperture efficiencies and occupy less space than typical microstrip patch arrays. The measured impedance bandwidths of the designed unidirectional slot arrays were 19.8, 15.3, and 16.7%, respectively, with peak gains of 11.7, 13.9, and 14.4 dBi. Measured results show very good agreement with the simulated results, which serves as validation of the array design procedure and the accuracy of the simulated results.

Keywords

Planar arraySlot arrayWLAN antennaAperture efficiency
Type
Research Papers
Information
International Journal of Microwave and Wireless Technologies , Volume 9 , Issue 2 , March 2017 , pp. 453 - 461
Copyright
Copyright © Cambridge University Press and the European Microwave Association 2015 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Chen, S.; Lan, I.; Hsu, P.: In-line series-feed collinear slot array fed by a coplanar waveguide. IEEE Trans. Antennas Propag., 55 (6) (2007), 1739–1744.Google Scholar
[2] Chen, S.; Hsu, P.: Open-ended rampart slot array antenna fed by a CPW. IEEE Antennas Wireless Propag. Lett., 4 (2005), 320–322.Google Scholar
[3] Denidni, T.A.; Hassaine, N.: Broadband and high-gain E-shaped microstrip antennas for high-speed wireless networks. Prog. Electromagn. Res. C, 1 (2008), 105–111.Google Scholar
[4] Soliman, E.A.; Brebels, S.; Vanderbosch, G.; Beyne, E.: X-band brick wall antenna fed by CPW. Electron. Lett., 34 (9) (1998), 836–838.CrossRefGoogle Scholar
[5] Soliman, E.A.; Brebels, S.; Beyne, E.; Delmotte, P.; Vanderbosch, G.: Brick-wall antenna in multilayer thin-film technology. Microw. Opt. Technol. Lett., 19 (5) (1998), 360–365.3.0.CO;2-4>CrossRefGoogle Scholar
[6] Joubert, J.; Odendaal, J.W.: 2 × 2 etched slot array with corporate slotline feed network. Electron. Lett., 44 (14) (2008), 833–834.Google Scholar
[7] Chen, S.; Hsu, P.: A CPW-fed horn-shaped slot array antenna for 5 GHz WLAN access point. 7th Euro. Conf. Wireless Technol., (2004), 281–284.Google Scholar
[8] Joubert, J.; Vardaxoglou, J.C.; Whittow, W.G.; Odendaal, J.W.: CPW-fed cavity-backed slot radiator loaded with an AMC reflector. IEEE Trans. Antennas Propag., 60 (2) (2012), 735–742.Google Scholar
[9] Ma, Z.; Vandenbosch, G.A.E.: Low-cost wideband microstrip arrays with high aperture efficiency. IEEE Trans. Antennas Propag., 60 (6) (2012), 3028–3034.Google Scholar
[10] Iizasa, N.; Pokharel, R.; Yoshitomi, K.: High gain 4 × 4 slot dipole antenna array in the 5 GHz band. 3rd Asia-Pacific Conf. Antennas Propag., (2014), 197–200.Google Scholar
[11] Wu, Z.-H.; Zhang, W.-X.: Broadband printed compound air-fed array antennas. IEEE Antennas Wireless Propag. Lett., 9 (2010), 187–190.Google Scholar
[12] Shuppert, B.: Microstrip/slotline transitions: modeling and experimental investigation. IEEE Trans. Microw. Theory Tech., 36 (8) (1988), 1272–1282.Google Scholar