Hostname: page-component-cd9895bd7-7cvxr Total loading time: 0 Render date: 2024-12-16T19:22:38.344Z Has data issue: false hasContentIssue false

A compact omnidirectional to directional frequency reconfigurable antenna for wireless sensor network applications

Published online by Cambridge University Press:  01 July 2021

Melvin Chamakalayil Jose*
Affiliation:
Electronics and Communication Engineering, Sri Sivasubramaniya Nadar College of Engineering, Anna University, Chennai, India
Radha Sankararajan
Affiliation:
Electronics and Communication Engineering, Sri Sivasubramaniya Nadar College of Engineering, Anna University, Chennai, India
Balakrishnapillai Suseela Sreeja
Affiliation:
Electronics and Communication Engineering, Sri Sivasubramaniya Nadar College of Engineering, Anna University, Chennai, India
Mohammed Gulam Nabi Alsath
Affiliation:
Electronics and Communication Engineering, Sri Sivasubramaniya Nadar College of Engineering, Anna University, Chennai, India
Pratap Kumar
Affiliation:
Electronics and Communication Engineering, Sri Sivasubramaniya Nadar College of Engineering, Anna University, Chennai, India
*
Author for correspondence: Melvin Chamakalayil Jose, E-mail: [email protected]

Abstract

In the proposed research paper, a novel compact, ultra-wideband electronically switchable dual-band omnidirectional to directional radiation pattern microstrip planar printed rectangular monopole antenna (PRMA) has been presented. The proposed antenna system has an optimum size of 0.26 λ0 × 0.28 λ0. A combination of radiators, reflectors, and two symmetrical grounds does place on the same layer of the rectangular microstrip PRMA. The frequency agility and the radiation pattern from omnidirectional to directional are achieved using two SMD PIN diodes (SMP1340-04LF). The directional radiation patterns with 180° phase shifts are achieved at the C-band frequency spectrum. The parametric study of the proposed antenna system was performed for different design parameters, and the antenna characteristics were analyzed. An antenna prototype is fabricated using the printed circuit board etching method by using RMI UV laser etching and cutting tools. The measurements of the proposed antenna are conducted in an anechoic chamber to validate the simulations. There are three states of operations due to two SMD PIN diodes being used in switching circuits. In state-I, the proposed antenna radiates at 6.185 GHz (5.275–6.6 75 GHz) in the Ф = 270° direction with a gain of 2.1 dBi, whereas in state-II, it radiates at 5.715 GHz (5.05–6.8 GHz) in the Ф = 90° direction with a gain of 2.1 dBi. In state-III, the antenna exhibits the X-band frequency with center frequency at 9.93 GHz (8.845–10.49 GHz), and the omnidirectional pattern offers a gain of 4.1 dBi. The features of the proposed antenna are suitable for high-speed wireless sensor network communication in industries such as chemical reactors in oil and gas and pharmaceuticals. It is also well suited for IoT and 5G-sub-6-GHz applications.

Type
Antenna Design, Modelling and Measurements
Copyright
Copyright © The Author(s), 2021. Published by Cambridge University Press in association with the European Microwave Association

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Christoudolou, CG, Tawk, Y, Lane, SA and Erwin, SR (2012) Reconfigurable antennas for wireless and space applications. Proceedings of the IEEE 100, 22502261.CrossRefGoogle Scholar
Li, PK, Shao, SH, Wang, Q and Cheng, YJ (2014) Frequency and pattern reconfigurable antenna for multi-standard wireless applications. IEEE Antennas and Wireless Propagation Letters 14, 333336.CrossRefGoogle Scholar
Ye, M and Gao, P (2015) Back-to-back F semi-circular antenna with frequency and pattern reconfigurability. Electronics Letters 51, 20732079.CrossRefGoogle Scholar
Zhang, J, Yan, S and Vandenbosch, GAE (2019) Metamaterial-inspired dual-band frequency-reconfigurable antenna with pattern diversity. Electronics Letters 55, 573574.CrossRefGoogle Scholar
Lim, I, Yun, T and Lim, S (2014) Low profile pattern-reconfigurable antenna with vertical and horizontal shorting lines in grounded CPW technology. IEEE Antennas and Wireless Propagation Letters 13, 15891592.CrossRefGoogle Scholar
Jusoh, M, Aboufoul, T, Sabapathy, T, Alomainy, A and Kamarudin, MR (2014) Pattern-reconfigurable microstrip patch antenna with multidirectional beam for WiMAX application. IEEE Antennas and Wireless Propagation Letters 13, 860863.CrossRefGoogle Scholar
Alam, MS and Abbosh, A (2016) Planar pattern reconfigurable antenna with eight switchable beams for WiMax and WLAN applications. IET Microwaves, Antennas and Propagation 10, 10301035.CrossRefGoogle Scholar
Lim, I and Lim, S (2013) Monopole-like and boresight pattern reconfigurable antenna. IEEE Transactions on Antenna and Propagation 61, 58545859.CrossRefGoogle Scholar
Yan, S and Vandenbosch, AE (2016) Radiation pattern reconfigurable wearable antenna based on metamaterial structure. IEEE Antennas and Wireless Propagation Letters 15, 17151718.CrossRefGoogle Scholar
Zhang, G-M, Hong, J–S, Song, G and Wang, B-Z (2012) Design and analysis of a compact wideband pattern-reconfigurable antenna with alternate reflector and radiator. IET Microwaves, Antennas & Propagation 6, 16291635.CrossRefGoogle Scholar
Ding, X and Wang, B-Z (2013) A novel wideband antenna with a reconfigurable broadside and end-fire patterns. IEEE Antennas and Wireless Propagation Letters 12, 995998.CrossRefGoogle Scholar
Lu, P and Yang, X-S (2019) Pattern reconfigurable rectenna with omni-directional/directional radiation modes for MPT with multiple transmitting antennas. IEEE Microwave and Wireless Components Letters 29, 826829.CrossRefGoogle Scholar
Zhu, X-Q, Guo, Y-X and Wu, W (2016) A novel dual-band for wireless communication applications. IEEE Antennas and Wireless Propagation Letters 15, 516519.CrossRefGoogle Scholar
Liu, B-J, Qiu, J-H, Lan, S-C and Li, G-Q (2019) A wideband-to-narrowband rectangular dielectric resonator antenna integrated with a tunable bandpass filter. IEEE Access 7, 6125161258.CrossRefGoogle Scholar
Kelly, JR and Hall, PS (2010) Integrated wide-narrow band antenna for switched operation. Microwave and Optical Technology Letters 52, 17051707.CrossRefGoogle Scholar
Rahardjo, ET, Zulkifli, FY and Widiastri, A. Printed antenna design for cognitive radio application at 1.8 GHz and 2.35 GHz spectrum allocation. Proceedings of IEEE, Asia Pacific Microwave Conference, USA; 2011: pp. 18811884.Google Scholar
Kandasamy, K and Ray, KP Design of SRR loaded reconfigurable antenna for UWB and narrowband applications. Proceedings of IEEE, International Symposium on Antennas and Propagation & USNC/URSI National Radio Science Meeting, Canada; 2015: pp. 11921193.CrossRefGoogle Scholar
Jin, GP and Zang, DL (2011) Optically controlled reconfigurable antenna for cognitive radio applications. Electronics Letters 47, 948950.CrossRefGoogle Scholar
Tawk, Y, Constantine, J, Avery, K and Christodoulou, CG (2011) Implementation of a cognitive radio front-end using rotatable controlled reconfigurable antennas. IEEE Transactions on Antennas and Propagation 59, 17731778.CrossRefGoogle Scholar
Boudaghi, H, Azarmanesh, M and Mehranpour, M (2012) A frequency reconfigurable monopole antenna using the switchable slotted ground structure. IEEE Antennas and Wireless Propagation Letters 11, 655658.CrossRefGoogle Scholar
Nejatijahromi, M, Naghshvarianjahromi, M and Rahman, MU (2018) Switchable planar monopole antenna between ultra-wideband and narrowband behavior. Progress in Electromagnetics Research Letters 75, 131137.CrossRefGoogle Scholar
Shlykevich, A, Bystricky, T and Blecha, T (2017) High-frequency properties of RF planar passive components. Periodica Polytechnica Electrical Engineering and Computer Science 61, 4853.Google Scholar
Ghaffar, A, Li, XJ, Awan, WA, Naqvi, AH, Hussain, N, Alibakhshikenari, M and Limiti, E (2021) A flexible and pattern reconfigurable antenna with small dimensions and simple layout for wireless communication systems operating over 1.65–2.51 GHz. Electronics 10, 601.CrossRefGoogle Scholar
Awan, WA, Hussain, N, Ghaffar, A, Zaidi, A, Naqvi, SI and Li, XJ (2020) A compact flexible frequency reconfigurable antenna for heterogeneous applications. IEEE Access 8, 173298173307.Google Scholar
Awan, WA, Hussain, N, Naqvi, SA, Iqbal, A, Striker, R, Mitra, D and Braaten, BD (2020) A miniaturized wideband and multiband on-demand reconfigurable antenna for compact and portable devices. AEU - International Journal of Electronics and Communications 122, 153266, ISSN 1434–8411.CrossRefGoogle Scholar
Zahra, H, Awan, WA, Ali, WAE, Hussain, N, Abbas, SM and Mukhopadhyay, S (2021) A 28 GHz broadband helical inspired end-fire antenna and its MIMO configuration for 5 G pattern diversity applications. Electronics 10, 405.CrossRefGoogle Scholar
Bhattacharjee, S, Analysis of printed monopole antennas (Doctoral Thesis), 2016.Google Scholar
Ray, KP (2008) Design aspects of printed monopole antennas for ultra-wide band applications. International Journal of Antennas and Propagation 2008, 18.CrossRefGoogle Scholar
Ghaffar, A, Li, XJ, Hussain, N and Awan, WA Flexible frequency and radiation pattern reconfigurable antenna for multi-band applications, 2020 4th Australian Microwave Symposium (AMS), Sydney, NSW, Australia, 2020, pp. 12.CrossRefGoogle Scholar
Ghaffar, A, Li, XJ, Ahmad, T, Hussain, N, Alibakhshikenari, M and Limiti, E, Circularly polarized pattern reconfigurable flexible antenna for 5G-sub-6-GHz applications, 2020 IEEE Asia-Pacific Microwave Conference (APMC), Hong Kong, Hong Kong, 2020, pp. 625627.CrossRefGoogle Scholar
Iqbal, A, Bouazizi, A, Smida, A, Basir, A and Naeem, U (2019) A low-profile dual-band antenna with on-demand beam switching capabilities. IET Microwaves Antennas & Propagation 14, 1520. doi: 10.1049/iet-map.2019.0401.CrossRefGoogle Scholar