Wing Section Design for Swept-Back Wings at Transonic Speeds

Extract

It is well known that the performance at high subsonic and transonic speeds of a swept-back wing-body combination in which the wing is untwisted and has the same section at all stations along the span and in which the body is not specially shaped to allow for the presence of the wing, falls far short of what would be predicted for the corresponding infinite sheared wing. For example, with a sweep of 45° and a thickness/chord ratio of 6 per cent it has been found experimentally that a rapid shock-induced increase in drag occurs above a Mach number of about 0·95 and a peak value of C_D is obtained at Mach numbers slightly in excess of 1·0, whereas it can be estimated that for the corresponding infinite sheared wing, sonic speed in a direction perpendicular to the isobars (the lines joining points where the pressure is equal) would not be obtained until a Mach number of 1·18 was reached. The poorer performance of the finite swept-back wing results principally from the fact that the pressure distributions for sections near the root and tip are distorted in shape from what would be obtained on an infinite sheared wing and, as a result, the isobars tend to lose some or all of their sweep. With a moderate aspect ratio such as 3, such effects extend over most of the span at high subsonic speeds.