Hostname: page-component-586b7cd67f-dlnhk Total loading time: 0 Render date: 2024-11-28T00:24:50.839Z Has data issue: false hasContentIssue false
  • English
  • Français

The ‘Chu-tube’: a velocimeter for use in highly-sheared, three-dimensional steady flows

Published online by Cambridge University Press:  04 July 2016

J. K. Chu ,
E. Rios-Chiquete ,
S. Sarohia  and
L. Bernstein
J. K. Chu
Affiliation:
Department of Aeronautical Engineering, Queen Mary College, London
E. Rios-Chiquete
Affiliation:
Department of Aeronautical Engineering, Queen Mary College, London
S. Sarohia
Affiliation:
Department of Aeronautical Engineering, Queen Mary College, London
L. Bernstein
Affiliation:
Department of Aeronautical Engineering, Queen Mary College, London
Get access Rights & Permissions [Opens in a new window]

Extract

A velocimeter is described based upon the same principle as the five-hole Conrad tube yawmeter. However it uses a single tube, cut obliquely at 45°, that rotates about its own axis together with an outer closely-fitting concentric tube, cut normal to its axis, that can be slid forward over the mouth of the chamfered tube. The small measuring volume, about 1 mm3, and well-defined measuring point enable the probe to be used with some confidence in regions of high shear. Some typical results obtained with the probe in a highly-sheared, three-dimensional flow are given.

Type
Research Article
Information
The Aeronautical Journal , Volume 91 , Issue 903 , March 1987 , pp. 142 - 149
Copyright
Copyright © Royal Aeronautical Society 1987 

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Bryer, D. W. and Pankhurst, R. C. Pressure-probe methods for determining wind speed and flow direction. National Physical Laboratory monograph, HMSO, 1971.Google Scholar
Chu, J. and Young, A. D. A further investigation of viscous effects in a wing-plate junction. QMC ER-1003, 1975.Google Scholar
MacMillan, F. A. Experiments on pitot-tubes in shear flow. ARC R&M 3028, 1956.Google Scholar
Naranjit, S. An investigation of the flow over a wing-body combination. PhD Thesis, London University, 1976.Google Scholar
Pankhurst, R. and Holder, D. W. Wind-tunnel technique. Pitman, London, 1952.Google Scholar
Pollatos, D. Fence effects on a low-speed wing. PhD Thesis, London Universitv, 1977.Google Scholar
Rios-Chiquete, E. Unpublished.Google Scholar
Sarohia, S. Unpublished.Google Scholar
Young, A. D. and Maas, J. N. The behaviour of a pitot-tube in a transverse total-pressure gradient. ARC R&M 1770, 1937.Google Scholar