Hostname: page-component-745bb68f8f-s22k5 Total loading time: 0 Render date: 2025-01-12T09:55:21.476Z Has data issue: false hasContentIssue false
  • English
  • Français

X-ray Residual Stress Measurements Using Parallel Beam Optics

Published online by Cambridge University Press:  06 March 2019

Richard M. Chrenko
Richard M. Chrenko*
Affiliation:
General Electric Research and Development Center Schenectady, New York 12301
Get access

Abstract

X-ray residual stress measurements have been made with a commercial portable X-ray diffraction apparatus that uses parallel beam optics and that was specifically designed for residual stress measurements. This machine differs from X-ray diffraction units using the usual parafocusing geometry in several respects, most notably reduced sample placement errors and larger sample sizes that can be accommodated. Two special modes of operation are available and will be discussed. These are the ability to use the side inclining method for stress analysis and the ability to use an oscillating ψ motion, the latter mode being useful for examining large grain size materials.

Type
X-Ray Diffraction Stress Analysis
Information
Advances in X-Ray Analysis , Volume 20: Twenty-Fifth Annual Conference on Applications of X-ray Analysis, August 4-6, 1976 , 1976 , pp. 393 - 402
Copyright
Copyright © International Centre for Diffraction Data 1976

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Aoyama, S., Satta, K., and Tada, M., “The Effect of Setup Errors on the Accuracy of Stress Measured with the Parallel Beam X-ray Diffractometer,” J. Soc. Mat. Sci., Japan, 17, 1071 (1968).Google Scholar
2. Fukura, J. and H.Fujiwara, , “Evaluation of Various Techniques of X-ray stress Measurement with the Diffractometer,” J. Soc. Mat. Sci., Japan, 15, 825 (1966).Google Scholar
3. Taira, S., “X-ray Diffraction Approach for Studies on Fatigue and Creep,” Experimental Mechanics, 13, 449 (1973).Google Scholar
4. “Residual stress Measurement by X-ray Diffraction,” SAE J 784a, Soc. Auto. Eng. (1971).Google Scholar
5. Jatczak, C. F. and Boehm, H. H., “The Effects of X-ray Optics on Residual Stress Measurements in Steel,” Adv. in X-ray Analysis, 17, 354, Plenum Press (1973).Google Scholar