We demonstrate direct electron beam writing of a nano-scale Cu pattern on a surface with a thin aqueous layer of CuSO4 solution. Electron beams are highly maneuverable down to nano-scales. Aqueous solutions facilitate a plentiful metal ion supply for practical industrial applications, which may require continued reliable writing of sophisticated patterns. A thin aqueous layer on a surface helps to confine the writing on the surface. For this demonstration, liquid sample holder (K-kit) for transmission electron microscope (TEM) was employed to form a sealed space in a TEM. The aqueous CuSO4 solution inside the sample holder was allowed to partially dry until a uniform thin layer was left on the surface. The electron beam thus reduced Cu ions in the solution to form the desired patterns. Furthermore, the influence of e-beam exposure time and CuSO4(aq) concentration on the Cu reduction was studied in this work. Two growth stages of Cu were shown in the plot of Cu thickness versus e-beam exposure time. The measured Cu reduction rate was found to be proportional to the CuSO4(aq) concentration.

In a recent publication by Abou-Ras et al., various techniques for the analysis of elemental distribution in thin films were compared, using the example of a 2-µm thick Cu(In,Ga)Se2 thin film applied as an absorber material in a solar cell. The authors of this work found that similar relative Ga distributions perpendicular to the substrate across the Cu(In,Ga)Se2 thin film were determined by 18 different techniques, applied on samples from the same identical deposition run. Their spatial and depth resolutions, their measuring speeds, their availabilities, as well as their detection limits were discussed. The present work adds two further techniques to this comparison: laser-induced breakdown spectroscopy and grazing-incidence X-ray fluorescence analysis.

We explore the interference fringes that arise in diffraction patterns from double-layer amorphous samples where there is a substantial separation, up to about a micron, between two overlapping thin films. This interferometric diffraction geometry, where both waves have interacted with the specimen, reveals phase gradients within microdiffraction patterns. The rapid fading of the observed fringes as the magnitude of the diffraction vector increases confirms that displacement decoherence is strong in high-energy electron scattering from amorphous samples. The fading of fringes with increasing layer separation indicates an effective illumination coherence length of about 225 nm, which is consistent with the value of 270 nm expected for the heated Schottky field emitter source. A small reduction in measured coherence length is expected because of the additional energy spread induced in the beam after it passes through the first layer.

This work presents a series of three-dimensional computational methods with the objective of analyzing and quantifying some important structural characteristics in a collection of low-density polyolefin-based foams. First, the solid phase tortuosity, local thickness, and surface curvature, have been determined over the solid phase of the foam. These parameters were used to quantify the presence of wrinkles located at the cell walls of the foams under study. In addition, a novel segmentation technique has been applied to the continuous solid phase. This novel method allows performing a separate analysis of the constituting elements of this phase, that is, cell struts and cell walls. The methodology is based on a solid classification algorithm and evaluates the local topological dissimilarities existing between these elements. Thanks to this method it was possible to perform a separate analysis of curvature, local thickness, and corrugation ratio in the solid constituents that reveals additional differences that were not detected in the first analysis of the continuous structure. The methods developed in this work are applicable to other types of porous materials in fields such as geoscience or biomedicine.