Dynamic characterization techniques have been utilized in the fields of biology, chemistry, physics, and materials science for many years. Techniques range from neutron scattering to X-ray diffraction. Two of the fields experiencing much development recently have been electron-based techniques. Namely, ultrafast electron diffraction (UED) and ultrafast electron microscopy (UEM) have been advancing rapidly, but unfortunately, in parallel. We are approaching an era where the convergence of these two techniques could open up a wide range of scientific and technological opportunities and advancements.

Extrapolating from a brief survey of the literature, we outline a vision for the future development of time-resolved electron probe instruments that could offer levels of performance and flexibility that push the limits of physical possibility. This includes a discussion of the electron beam parameters (brightness and emittance) that limit performance, the identification of a dimensionless invariant figure of merit for pulsed electron guns (the number of electrons per lateral coherence area, per pulse), and calculations of how this figure of merit determines the trade-off of spatial against temporal resolution for different imaging modes. Modern photonics' ability to control its fundamental particles at the quantum level, while enjoying extreme flexibility and a very large variety of operating modes, is held up as an example and a goal. We argue that this goal may be approached by combining ideas already in the literature, suggesting the need for large-scale collaborative development of next-generation time-resolved instruments.

Ultrafast electron diffraction (UED) enables studies of structural dynamics at atomic length and timescales, i.e., 0.1 nm and 0.1 ps, in single-shot mode. At present UED experiments are based on femtosecond laser photoemission from solid state cathodes. These photoemission sources perform excellently, but are not sufficiently bright for single-shot studies of, for example, biomolecular samples. We propose a new type of electron source, based on near-threshold photoionization of a laser-cooled and trapped atomic gas. The electron temperature of these sources can be as low as 10 K, implying an increase in brightness by orders of magnitude. We investigate a setup consisting of an ultracold electron source and standard radio-frequency acceleration techniques by GPT tracking simulations. The simulations use realistic fields and include all pairwise Coulomb interactions. We show that in this setup 120 keV, 0.1 pC electron bunches can be produced with a longitudinal emittance sufficiently small for enabling sub-100 fs bunch lengths at 1% relative energy spread. A transverse root-mean-square normalized emittance of εx = 10 nm is obtained, significantly better than from photoemission sources. Correlations in transverse phase-space indicate that the transverse emittance can be improved even further, enabling single-shot studies of biomolecular samples.

Radio-frequency (RF) photoinjector-based relativistic ultrafast electron diffraction (UED) is a promising new technique that has the potential to probe structural changes at the atomic scale with sub-100 fs temporal resolution in a single shot. We analyze the limitations on the temporal and spatial resolution of this technique considering the operating parameters of a standard 1.6 cell RF gun (which is the RF photoinjector used for the first experimental tests of relativistic UED at Stanford Linear Accelerator Center; University of California, Los Angeles; Brookhaven National Laboratory), and study the possibility of employing novel RF structures to circumvent some of these limits.

We present a characterization of the performance of an ultrashort laser pulse driven DC photoelectron gun based on the thermionic emission gun design of Togawa et al. [Togawa, K., Shintake, T., Inagaki, T., Onoe, K. & Tanaka, T. (2007). Phys Rev Spec Top-AC10, 020703]. The gun design intrinsically provides adequate optical access and accommodates the generation of ∼1 mm2 electron beams while contributing negligible divergent effects at the anode aperture. Both single-photon (with up to 20,000 electrons/pulse) and two-photon photoemission are observed from Ta and Cu(100) photocathodes driven by the harmonics (∼4 ps pulses at 261 nm and ∼200 fs pulses at 532 nm, respectively) of a high-power femtosecond Yb:KGW laser. The results, including the dependence of the photoemission efficiency on the polarization state of the drive laser radiation, are consistent with expectations. The implications of these observations and other physical limitations for the development of a dynamic transmission electron microscope with sub-1 nm·ps space-time resolution are discussed.

A variety of ways is described in which photons can be used not only for ultrafast electron microscopy but also to enormously widen the energy range of spatially-resolved electron spectroscopy. Periodic chains of femtosecond laser pulses are a particularly important and accurately timed source for single-shot imaging and diffraction as well as for several forms of pump-probe microscopy at even higher spatial resolution and sub-picosecond timing. Many exciting new fields are opened up for study by these developments. Ultrafast, single shot diffraction with intense pulses of X-rays supplemented by phase retrieval techniques may eventually offer a challenging alternative and purely photon-based route to dynamic imaging at high spatial resolution.

We review the development of ultrafast electron nanocrystallography as a method for investigating structural dynamics for nanoscale materials and interfaces. Its sensitivity and resolution are demonstrated in the studies of surface melting of gold nanocrystals, nonequilibrium transformation of graphite into reversible diamond-like intermediates, and molecular scale charge dynamics, showing a versatility for not only determining the structures, but also the charge and energy redistribution at interfaces. A quantitative scheme for 3D retrieval of atomic structures is demonstrated with few-particle (<1,000) sensitivity, establishing this nanocrystallographic method as a tool for directly visualizing dynamics within isolated nanomaterials with atomic scale spatio-temporal resolution.

All clinically-approved and many novel gadolinium (Gd)-based contrast agents used to enhance signal intensity in magnetic resonance imaging (MRI) are optically silent. To verify MRI results, a “gold standard” that can map and quantify Gd down to the parts per million (ppm) levels is required. Nuclear microscopy is a relatively new technique that has this capability and is composed of a combination of three ion beam techniques: scanning transmission ion microscopy, Rutherford backscattering spectrometry, and particle induced X-ray emission used in conjunction with a high energy proton microprobe. In this proof-of-concept study, we show that in diseased aortic vessel walls obtained at 2 and 4 h after intravenous injection of the myeloperoxidase-senstitive MRI agent, bis-5-hydroxytryptamide-diethylenetriamine-pentaacetate gadolinium, there was a time-dependant Gd clearance (2 h = 18.86 ppm, 4 h = 8.65 ppm). As expected, the control animal, injected with the clinically-approved conventional agent diethylenetriamine-pentaacetate gadolinium and sacrificed 1 week after injection, revealed no significant residual Gd in the tissue. Similar to known in vivo Gd pharmacokinetics, we found that Gd concentration dropped by a factor of 2 in vessel wall tissue in 1.64 h. Further high-resolution studies revealed that Gd was relatively uniformly distributed, consistent with random agent diffusion. We conclude that nuclear microscopy is potentially very useful for validation studies involving Gd-based magnetic resonance contrast agents.

Nuclear microscopy is a suite of techniques based on a focused beam of MeV protons. These techniques have the unique ability to image density and structural variations in relatively thick tissue sections, map trace elements at the cellular level to the microgram per gram (dry weight) level, and extract quantitative information on these elements. The trace elemental studies can be carried out on unstained freeze-dried tissue sections, thereby minimizing any problems of contamination or redistribution of elements during conventional staining and fixing procedures. The pancreas is a gland with different specialized cells and a complex hormonal activity where trace elements play an important role. For example, zinc has an active role in insulin production, and calcium ions participate in the stimulation and secretion process of insulin. Using nuclear microscopy with a spatial resolution of 1 μm, we have located, using zinc mapping, the islets of Langerhans in freeze-dried normal rabbit tissue sections. The islets of Langerhans contain β-cells responsible for insulin production. Subsequent quantitative analyses have indicated elevations in most elements within the islets of Langerhans, and significantly so for the concentrations of Zn [3,300 compared to 90 μg/g (dry weight)] and Ca [1,100 compared to 390 μg/g (dry weight)].

Quantification of immunostaining is a widely used technique in pathology. Nonetheless, techniques that rely on human vision are prone to inter- and intraobserver variability, and they are tedious and time consuming. Digital image analysis (DIA), now available in a variety of platforms, improves quantification performance: however, the stability of these different DIA systems is largely unknown. Here, we describe a method to measure the reproducibility of DIA systems. In addition, we describe a new image-processing strategy for quantitative evaluation of immunostained tissue sections using DAB/hematoxylin-stained slides. This approach is based on image subtraction, using a blue low pass filter in the optical train, followed by digital contrast and brightness enhancement. Results showed that our DIA system yields stable counts, and that this method can be used to evaluate the performance of DIA systems. The new image-processing approach creates an image that aids both human visual observation and DIA systems in assessing immunostained slides, delivers a quantitative performance similar to that of bright field imaging, gives thresholds with smaller ranges, and allows the segmentation of strongly immunostained areas, all resulting in a higher probability of representing specific staining. We believe that our approach offers important advantages to immunostaining quantification in pathology.

Clitoria ternatea is known for its antimicrobial activity but the antifungal effects of leaf extract on growth and morphogenesis of Aspergillus niger have not been observed. The extract showed a favorable antifungal activity against A. niger with a minimum inhibition concentration 0.8 mg/mL and minimum fungicidal concentration 1.6 mg/mL, respectively. The leaf extract exhibited considerable antifungal activity against filamentous fungi in a dose-dependent manner with 0.4 mg/mL IC50 value on hyphal growth of A. niger. The main changes observed under scanning electron microscopy after C. ternatea extract treatment were loss of cytoplasm in fungal hyphae and the hyphal wall and its diameter became markedly thinner, distorted, and resulted in cell wall disruption. In addition, conidiophore alterations were also observed when A. niger was treated with C. ternatea leaf extract.