The fraction of organic matter present affects the fragmentation behavior of sialoliths; thus, pretherapeutic information on the degree of mineralization is relevant for a correct selection of lithotripsy procedures. This work proposes a methodology for in vivo characterization of salivary calculi in the pretherapeutic context. Sialoliths were characterized in detail by X-ray computed microtomography (μCT) in combination with atomic emission spectroscopy, Fourier transform infrared spectroscopy, X-ray diffraction, scanning electron microscopy, and transmission electron microscopy. Correlative analysis of the same specimens was performed by in vivo and ex vivo helical computed tomography (HCT) and ex vivo μCT. The mineral matter in the sialoliths consisted essentially of apatite (89 vol%) and whitlockite (11 vol%) with average density of 1.8 g/cm3. In hydrated conditions, the mineral mass prevailed with 53 ± 13 wt%, whereas the organic matter, with a density of 1.2 g/cm3, occupied 65 ± 10% of the sialoliths’ volume. A quantitative relation between sialoliths mineral density and X-ray attenuation is proposed for both HCT and μCT.

The ability to accurately measure body or carcass composition is important for performance testing, grading and finally selection or payment of meat-producing animals. Advances especially in non-invasive techniques are mainly based on the development of electronic and computer-driven methods in order to provide objective phenotypic data. The preference for a specific technique depends on the target animal species or carcass, combined with technical and practical aspects such as accuracy, reliability, cost, portability, speed, ease of use, safety and for in vivo measurements the need for fixation or sedation. The techniques rely on specific device-driven signals, which interact with tissues in the body or carcass at the atomic or molecular level, resulting in secondary or attenuated signals detected by the instruments and analyzed quantitatively. The electromagnetic signal produced by the instrument may originate from mechanical energy such as sound waves (ultrasound – US), ‘photon’ radiation (X-ray-computed tomography – CT, dual-energy X-ray absorptiometry – DXA) or radio frequency waves (magnetic resonance imaging – MRI). The signals detected by the corresponding instruments are processed to measure, for example, tissue depths, areas, volumes or distributions of fat, muscle (water, protein) and partly bone or bone mineral. Among the above techniques, CT is the most accurate one followed by MRI and DXA, whereas US can be used for all sizes of farm animal species even under field conditions. CT, MRI and US can provide volume data, whereas only DXA delivers immediate whole-body composition results without (2D) image manipulation. A combination of simple US and more expensive CT, MRI or DXA might be applied for farm animal selection programs in a stepwise approach.

This paper presents a nondestructive measurement technique for the determination of the film thicknesses of Co and SmCo based magnetic films deposited by sputtering on single-crystal silicon (100) substrates. X-ray diffraction of Cu Kα radiation has been used to measure the intensity of the (400) reflection from bare silicon substrates and as attenuated by sputter coated Co and SmCo based films on Si substrates. A four-axis research diffractometer allowed the substrate orientation to be fine adjusted to maximize the (400) diffraction intensity. The thickness of SmCo based films was in a range from 0.05 to 5 μm. Co film thicknesses on Si could be measured to a few tens of nanometers. The accuracy of the thickness measurements depends on the effective mass attenuation coefficient of the film material. For the materials considered, the thicknesses determined by the X-ray attenuation method agree within at least several percent to values determined by other methods.