Infrared and Mössbauer spectroscopy show that the extent of the reduction of nontronite is dependent on the chemical composition of the nontronite and on the nature of the reducing agent. Hydrazine reversibly reduces about 10% of the iron in all of the nontronites studied irrespective of composition and it is suggested that the resulting ferrous iron occurs only in distorted octahedral sites. Similar conclusions are reached for the dithionite reduction of the nontronites containing little tetrahedral iron, but for those with more than one in eight silicons replaced by iron, changes brought about by dithionite treatment are irreversible due to dissolution of appreciable quantities of iron. Results from both spectroscopic techniques suggest that iron in tetrahedral sites is preferentially dissolved and that up to 80% of the structural iron can be reduced.

Evidence is presented for the formation in these extensively reduced nontronites of a small amount of a mica-like phase resembling celadonite or glauconite, and, as dithionite is used for the pretreatment of soils, the implication of this observation is briefly discussed.

The use of deuterated hydrazine as a reducing agent has enabled the nontronite absorption band near 850 cm-1 to be assigned to a Si-O (apical) stretching vibration, which is inactive in the infrared for perfect hexagonal symmetry, but which is activated by distortions in the tetrahedral layer.

Using Garfield, Washington, nontronite as the model mineral system, methods and apparatus were developed to prepare reduced suspensions in citrate-bicarbonate-dithionite (CBD) solution. These techniques were effective in removing excess, undesired solutes from reduced suspensions while maintaining a high Fe2+ content. They also enabled the preparation of dried, reduced films preferentially oriented with respect to the crystallographic c-axis. Supernatant solutions were collected and analyzed for Fe, Al, and Si, from which the extent of dissolution of the clay as a result of CBD treatment was assessed. Results indicated that very little Fe and Si were released to solution, but as much as about 8% of the total Al was solubilized. The highest levels of Al in solution were observed in CB treatments without dithionite.

A new iron oxide dissolution method designed to measure the abundance of “free” Fe oxide phases and associated elements in soils and sediments has been tested. The method employs a ternary complex of Ti(III), citrate, and ethylenediaminetetraacetate (EDTA) as a reductant and bicarbonate as a proton acceptor. The Ti(III)-citrate-EDTA-HCO3 method dissolved more synthetic amorphous ferric oxide and goethite, but less synthetic hematite, than the dithionite-citrate-HCO3 method of Mehra and Jackson. The production of acidity by the dissolution indicated that Ti(IV) is hydrolyzed to TiO2 during the extractions. The heated dithionite method dissolved 3–6 times more Al from kaolinite and nontronite standard clays than room temperature dithionite, and 4–6 times more Al than the Ti(III)-citrate-EDTA-HCO3 method. Furthermore, the release of Fe from the clay mineral samples consistently and rapidly reached a plateau during multiple extractions by the Ti(III)-citrate-EDTA-HCO3 method, indicating that a well-defined Fe oxide fraction was removed. Fe released by the dithionite method continued to increase with each extraction, suggesting that some release of structural Fe occurred. Tests on two natural sediments and one heavy mineral fraction from the Miocene Cohansey Sand in the New Jersey Coastal Plain suggested that the Ti(III)-citrate-EDTA-HCO3 method removed Fe oxides more effectively and more selectively than the dithionite method. The selectivity of the Ti(III)-citrate-EDTA-HCO3 method is enhanced by rapid extractions at room temperature and low free ligand concentrations.

Structural Fe in ferruginous smectite (sample SWa-1, Source Clays Repository of the Clay Minerals Society) was reduced by a mixture of five Pseudomonas species of bacteria in a defined Fe-free medium to determine the effect of microbial reduction on clay swelling. Iron(II), total Fe, and gravimetric water content (mw/mc) were determined in clay gels equilibrated at applied pressures of 0.1, 0.3, and 0.5 MPa. The water content of microbially reduced SWa-1 decreased at all three applied pressures as the Fe(II) content approached about 0.8 mmol Fe(II)/g-clay. As Fe(II) increased from 0.8 mmol/g-clay, however, further change in mw/mc was negligible. Concurrent with microbial reduction of structural Fe was a significant decrease in the swelling pressure (PI) of SWa-1: for example, when mw/mc = 1.2 (g/g), PI changed from 0.47 MPa at Fe(II) = 0.2, to 0.19 MPa at Fe(II) = 0.9 mmol/g-clay. Both biologically and chemically reduced smectites displayed lower values of mw/mc and a concurrent decrease in II as Fe(II) content increased, but the effect of Fe(II) on mw/mc was greater for the microbially reduced smectites at all applied pressures.

A synergistic effect of reductant and complexant is observed in the dissolution of goethite by dithionite and citrate or EDTA. The rate data are interpreted using the surface complexation approach to describe the interface of the reacting oxide. Adsorption of both S2O42− (D) and complexant (L) generates three surface complexes that define the dissolution behavior: ≡ Fe-D, ≡ Fe-L, and dimeric surface complexes. The initial rate increases at lower pH values because of increased surface complexation conditional formation constants. At pH values below 4, however, the fast decomposition of S2O42− gives rise to a rapid depletion of reductant, and total dissolution is not observed. It is shown that for best analytical results in soil analysis, EDTA is a better complexant than citrate; the iron extracted in one dithionite-EDTA treatment at pH 5–6, under N2 at 315 K is not increased by increasing the number of extractions, and is equivalent to the total extractable iron found by previous procedures.

The oxidation state of structural iron greatly influences the physical-chemical properties of clay minerals, a phenomenon that may have significant implications for pollutant fate in the environment, for agricultural productivity, and for industrial uses of clays. Knowledge of redox mechanisms is fundamental to understanding the underlying basis for iron's effects on clays. Past studies revealed that the extent of Fe reduction varied depending on the reducing agent used, but this variation may not have been a simple function of the reduction potential of the reducing agent. The objective of this study was to identify the relationship between the Fe reduction mechanism and free radical activity in the reducing agent. Several reducing agents and their mixtures with the Na-saturated, 0.5 to 2 μm size fraction of ferruginous smectite (SWa-1) were analyzed by electron spin resonance (ESR) spectroscopy to determine the presence of unpaired electrons or free radicals. Only Na2S2O4 exhibited paramagnetic free-radical behavior with a signal at about g = 2.011, which was attributed to the sulphoxylate (S02− ·) free radical. The free radical was labile in aqueous solution, and the ability of Na2S2O4 solution to reduce structural Fe in the smectite decreased with age of the solution and paralleled the disappearance of the free radical signal in the ESR spectrum. The paramagnetic species was preserved and enhanced if Na2S2O4 was added to the clay suspension, indicating that either the clay surface stabilized the SO2− · radical or the additional unpaired electrons were produced in the clay structure.