We compared elastic moduli in polar firn derived from diving wave refraction seismic velocity analysis, firn-core density measurements and microstructure modelling based on firn-core data. The seismic data were obtained with a small electrodynamic vibrator source near Kohnen Station, East Antarctica. The analysis of diving waves resulted in velocity–depth profiles for different wave types (P-, SH- and SV-waves). Dynamic elastic moduli of firn were derived by combining P- and S-wave velocities and densities obtained from firn-core measurements. The structural finite-element method (FEM) was used to calculate the components of the elastic tensor from firn microstructure derived from X-ray tomography of firn-core samples at depths of 10, 42, 71 and 99 m, providing static elastic moduli. Shear and bulk moduli range from 0.39 to 2.42 GPa and 0.68 to 2.42 GPa, respectively. The elastic moduli from seismic observations and the structural FEM agree within 8.5% for the deepest achieved values at a depth of 71 m, and are within the uncertainty range. Our observations demonstrate that the elastic moduli of the firn can be consistently obtained from two independent methods which are based on dynamic (seismic) and static (tomography and FEM) observations, respectively, for deeper layers in the firn below ~10 m depth.

Geophysicists that deploy seismic sensors in ablation zones of glaciers and ice sheets to record glaciogenic signatures can confront recording challenges caused by instrument melt-out or tilt. These challenges often require installing sensors in boreholes to delay melt-out, or securing sensors to structures that improve coupling. We show that some of these structures that were buried near a moulin at a snow-free site in the ablation zone of the Western Greenland Ice Sheet resonated as they became exposed, and caused their geophones to record temporally evolving, narrowband signals that mimic features of glaciogenic sources like moulin tremor. We quantify these artifacts with a mechanical model that shows instruments undergo structural resonance as they melt-out, at exposure rates that we predict from an ablation model (RACMO). These models reproduce general spectral features in our data, and enable us to estimate what instrument exposure reduces ice-to-sensor coupling enough to prevent icequake detection. Last, we use our resonance data to quantitatively measure how narrowband signals that originate from either artificial or glaciogenic sources will reduce the ability of certain waveform detectors (correlators) to capture transient seismic events, even if sensors remain coupled.