This paper presents a novel tendon-driven bio-inspired robotic hand design for in-hand manipulation. Many dexterous robot hands are able to produce adaptive grasping, but only a few human-sized hands worldwide are able to produce fine motions of the object in the hand. One of the challenges for the near future is to develop human-sized robot hands with human dexterity. Most of the existing hands considered in the literature suffer from dry friction which creates unwanted backlash and non-linearities. These problems limit the accurate control of the fingers and the capabilities of the hand. Such was the case with our first fully actuated dexterous robot hand: the Laboratoire de Mécanique des Solides (LMS) hand.

The mechanical design of the hand relies on a tendon-based transmission system. Developing a fully actuated dexterous robot hand requires the routing of the tendons through the finger for the actuation of each joint. This paper focuses on the evolution of the tendon routing; from the LMS hand to the new RoBioSS dexterous hand. The motion transmission in the new design creates purely linear coupling relations between joints and actuators. Experimental results using the same protocol for the previous hand and the new hand illustrate the evolution in the quality of the mechanical design. With the improvements of the mechanical behavior of the robotic fingers, the hand control software could be extensively simplified. The choice of a common architecture for all fingers makes it possible to consider the hand as a collaboration of four serial robots. Moreover, with the transparency of the motor-joint transmissions, we could use robust, industrial-grade cascaded feedback loops for the axis controls.

An inside-hand manipulation task concerning the manipulation of a bottle cap is presented at the end of the paper. As proof of the robustness of the hand, demonstrations of the hand's capabilities were carried out continuously over three days at SPS IPC Drives international exhibition in Nuremberg, in November 2016.

This paper outlines the analysis methodology employed in the design of an anthropomorphic hand for the purposes of object handling by robotic manipulators, and for prosthetics. The final design is described and the safe handling of various objects using this anthropomorphic hand is discussed.

In order to widen the potentialities of manipulation of the Laboratoire de Mécanique des solides (LMS) mechanical hand, we developed a new planning approach based on the use of a specific exoskeleton. This one has kinematics architecture and dimensions identical to the mechanical hand. This feature allows us to obtain manipulation trajectories for the mechanical hand, very easily and very quickly, by using the exoskeleton, without complex calibration. Manipulation's trajectories are replayed offline with an autonomous control, and, consequently, the exoskeleton is not used with any feedback strategy for telemanipulation. This paper presents the characteristics of this exoskeleton and the graphic interface that we developed. This one uses a method to determine the object's evolution during the manipulation with the exoskeleton, without using exteroceptive sensors. This new approach was tested for standard trajectories by simulation on a Computer-aided design (CAD) robotics system and by using the mechanical hand. Thus, we validate the use concept of an isomorphic exoskeleton to mechanical hand for manipulation planning with the LMS mechanical hand.