Hostname: page-component-586b7cd67f-dsjbd Total loading time: 0 Render date: 2024-11-24T18:21:06.465Z Has data issue: false hasContentIssue false
  • English
  • Français

The Zeolite ZSM-5 membrane study; synthesis, permeation and modeling.

Published online by Cambridge University Press:  11 February 2011

Bovornlak Oonkhanond  and
Michael E. Mullins
Bovornlak Oonkhanond
Affiliation:
Chemical Engineering Department, Michigan Technological University, 1400 Townsend Drive Houghton, MI 49931
Michael E. Mullins
Affiliation:
Chemical Engineering Department, Michigan Technological University, 1400 Townsend Drive Houghton, MI 49931
Get access

Abstract

Zeolite particles formed in the synthesis solution assume a negative charge due to electrical double layer effects. The membranes synthesized via electrophoretic deposition produce a thin continuous zeolite ZSM-5 layer on the porous alumina substrates. The thickness of membranes can be controlled by varying the precursor concentration, applied potential, and synthesis time. The permeation for a variety of gases through the membranes is examined. The diffusion properties are measured at near ambient temperature and pressure. Selectivity of n-butane over iso-butane is observed on every membrane. The diffusion coefficient of gases on ZSM-5 is also evaluated by gas adsorption on zeolite powders. The results of these studies show an ability to predict the effective diffusion coefficients. The estimation of molar fluxes across the membranes using the Maxwell-Stefan approach predicts a higher flux for thinner membranes. However, the calculations also show that even minor defects in the membrane have a great effect on the permeation rates.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 752: Symposium AA – Membranes–Preparation, Properties and Applications , 2002 , AA2.4
Copyright
Copyright © Materials Research Society 2003

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1 Oonkhanond, B. and Mullins, Michael E., J. Mem. Sci., 194, 3–13 (2001)Google Scholar
2 Krishna, R., van den Broeke, L.J.P, The Chemical Engineering Journal, 57, 155 (1995)Google Scholar
3 Krishna, R., Wesselingh, J.A, Chemical Engineering Science, 52 (6), 861–991 (1997)Google Scholar
4 Carslaw, H.S. and Jaeger, J.C., Conduction of Heat in Solids, 2nd ed. (Oxford at the Clarendon Press, 1959) pp. 230–350.Google Scholar
5 Yan, Y., Tsapatsis, M., Gavalas, G.R., and Davis, M.E., J. Chem. Soc., Chem. Commun., 227 (1995)Google Scholar
6 Yan, Y., Davis, M.E., and Gavalas, G.R., Ind. Eng. Chem. Res., 34, 1652 (1995)Google Scholar
7 Kallio, E.T., Master thesis, Michigan Technological University 2000 Google Scholar
8 Oonkhanond, B., Master thesis, Michigan Technological University, 2000.Google Scholar
9 Wu, E.L., Lawton, S.L., Olson, D.H., Rohrman, A.C., and Kokotailo, G.T., The Journal of Physical Chemistry, 83, 2777 (1979)Google Scholar
10 Shah, D.B., Chokchai-acha, S. and Hayhurst, D.T., J. Chem. Soc. Faraday Trans., 89 3161 (1993)Google Scholar
11 Müller, G., Narbeshuber, T., Mirth, G., and Lercher, J.A., J. Phys. Chem. 98 7436 (1994)Google Scholar