Hostname: page-component-586b7cd67f-vdxz6 Total loading time: 0 Render date: 2024-11-30T23:15:47.747Z Has data issue: false hasContentIssue false

Synthesis and Thermoelectric Properties of Y Doped SrTiO3 by Modified Pechini's Method

Published online by Cambridge University Press:  01 February 2011

Hirofumi Takenouchi
Affiliation:
[email protected], Tokyo University of Science, Department of Materials Science and Technology, 2641 Yamazaki, Noda-shi, 278-8510, Japan
Tomohiro Imai
Affiliation:
[email protected], Tokyo University of Science, Department of Physics, 2641 Yamazaki, Noda-shi, 278-8510, Japan
Hideo Mae
Affiliation:
[email protected], Yamaguchi Prefectural Industrial Technology Institute, 4-1-1 Asutopia, Ube-shi, 755-0195, Japan
Masakatsu Fujimoto
Affiliation:
[email protected], Yamaguchi Prefectural Industrial Technology Institute, 4-1-1 Asutopia, Ube-shi, 755-0195, Japan
Tohru Kineri
Affiliation:
[email protected], Tokyo University of Science, Yamaguchi, Department of Materials Science and Environmental Engineering, 1-1-1 Daigaku-Dori, Sanyoonoda-shi, 756-0884, Japan
Tsutomu Iida
Affiliation:
[email protected], Tokyo University of Science, Department of Materials Science and Technology, 2641 Yamazaki, Noda-shi, 278-8510, Japan
Noriaki Hamada
Affiliation:
[email protected], Tokyo University of Science, Department of Physics, 2641 Yamazaki, Noda-shi, 278-8510, Japan
Tsuneo Watanabe
Affiliation:
[email protected], Tokyo University of Science, Department of Applied Electronics, 2641 Yamazaki, Noda-shi, 278-8510, Japan
Keishi Nishio
Affiliation:
[email protected], Tokyo University of Science, Department of Materials Science and Technology, 2641 Yamazaki, Noda-shi, 278-8510, Japan
Get access

Abstract

Thermoelectric properties of Sr1-xYxTiO3 (x = 0-0.08) were calculated using a virtual crystal method. Using a Pechini's method, Sr1-xYxTiO3 (x = 0-0.06) precursor powder was prepared. Using this method, we prepared pure SrTiO3 at a lower temperature than would be using the conventional solid-state reaction method. The precursor solution was heated at 823 K for 5 h after drying at 353 K for 8 h to produce the precursor powder. The powder was sintered using a hot pressing technique. The relative densities of ceramics were more than 98%. The Seebeck coefficient and electrical conductivity of the samples were measured using the standard four-probe method in a flowing He gas atmosphere in a temperature range of 323 to 923 K. The conductivities of SrTiO3, Sr0.97Y0.03TiO3, and Sr0.94Y0.06TiO3 at room temperature were 6.61 × 102, 5.61 × 103, and 1.58 × 104 S/m, respectively. The Seebeck coefficients of SrTiO3, Sr0.97Y0.03TiO3, and Sr0.94Y0.06TiO3 at room temperature were -548, -264, and -196 μV/K, respectively.

Type
Research Article
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Funahasi, R. et al. , “An oxide single crystal with high thermoelectric performance in air”, Jpn. J. Appl. Phys., Vol. 39, No. 11B (2000), pp. L1127–L1129Google Scholar
2. Ohtakai, M et al. , “Improved thermoelectric performance of of sintered NaCo2O4 with enhanced 2-dimensional microstructure””, Proc. 19th Int. Conf. on thermoelectrics, Cardiff, UK, 2000, pp. 190195.Google Scholar
3. Hui, S. and Petric, A., J. Electrochem. Soc. 149 (2002) J1.Google Scholar
4. Obara, H. et al. , “Thermoelectric Properties of Y-Doped Polycrystaline SrTiO3 Jppn. J. Appl. Phys, Vol.43, No.4B. (2004), pp L540–L542.Google Scholar
5. Moos, R. et al. , “Thermopower of Sr1-xLaxTiO3 ceramics” J. Appl. Phys, Vol.78 (1995), pp 50425047.Google Scholar
6. S, Ohta. et al. , Appl. Phys. Lett. (2005) 87 092108 Google Scholar
7. S, Ohta. et al. , J. Chem. Soc. Jpn. (2006) 114, 102 Google Scholar
8. Hanxing, L. et al. , Acta Phy. Chem. Sinca 4 (7) (1998), pp624629 Google Scholar
9. Deium, W. et al. , J. Inorg. Matter. 12 (2) (1996), pp 231236 Google Scholar
10. Kiss, K., Manger, J., Ferroelectrics of ultrafine particle size, J. Am. Ceram. Soc. 49 (1966) 291295 Google Scholar
11. Pechini, M., Sprague Electric Co., U.S. Pnt., 1967, #3, 330, 697.Google Scholar
12. Hamada, N. et al. , J. Phys. Condens. Matter (2007) 19 365221 Google Scholar
13. Shannon, R. D., Acta Crystallogr., Sect. A: Cryst. Phys., Diffr., Theor. Gen. Crystallogr., 32, 751 (1976)Google Scholar
14. Wintcr, M., www.wcbclcments.com, University of Sheffield, England.Google Scholar