Hostname: page-component-745bb68f8f-mzp66 Total loading time: 0 Render date: 2025-01-12T09:31:08.520Z Has data issue: false hasContentIssue false
  • English
  • Français

Mechanical Properties of Compositionally Modulated Au-Ni thin films using Indentation and Microbeam Deflection Techniques

Published online by Cambridge University Press:  16 February 2011

Shefford P. Baker ,
Alan F. Jankowski ,
Soonil Hong  and
William D. Nix
Shefford P. Baker
Affiliation:
Stanford University, Department of Materials Science and Engineering, Building 550, Stanford, CA 94305
Alan F. Jankowski
Affiliation:
Lawrence Livermore National Laboratory, P.O. Box 808, L-350, Livermore, CA 94550
Soonil Hong
Affiliation:
Stanford University, Department of Materials Science and Engineering, Building 550, Stanford, CA 94305
William D. Nix
Affiliation:
Stanford University, Department of Materials Science and Engineering, Building 550, Stanford, CA 94305
Get access

Abstract

The “supermodulus effect” has been reported as an anomalous increase of as much as several hundred percent in the elastic moduli of compositionally-modulated thin metal films in a narrow range of modulation wavelength. The direct measurement of this effect has, however, been limited due to the very small dimensions of the test material. The mechanical properties of compositionally-modulated Au-Ni thin films (one of the first systems in which the supermodulus effect was reported) were studied on their substrates by indentation and microbeam-deflection techniques using a Nanoindenter. The films were fabricated by alternately sputtering Au and Ni onto [100] Si substrates for the indentation tests and onto prefabricated SiO2 cantilever beams with an initial Cr layer (for adhesion) for the beam deflection tests. All of the films have strong [111] textures and exhibit the structural characteristics of the films for which the modulus enhancement was reported. In particular, an increase in the average lattice parameter normal to the plane of the film over a narrow range of modulation wavelengths near 2 nm was noted. The modulation wavelengths range from 0.8 to 4.5 nm. The results from both indentation and microbeam deflection tests reveal no unusual plastic or elastic properties in these samples.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 188: Symposium K – Thin Films: Stresses and Mechanical Properties II , 1990 , 289
Copyright
Copyright © Materials Research Society 1990

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

1. Yang, W.M.C., Tsakalakos, T., and Hilliard, J.E., J. Appl. Phys. 48 876 (1977)Google Scholar
2. Testardi, L.R., Willens, R.H., Krause, J. T., McWhan, D.B. and Nakahara, S., J. Appl. Phys. 52, 510 (1981)Google Scholar
3. Henein, G.E. and Hilliard, J.E., J. Appl. Phys. 54, 728 (1983)Google Scholar
4. Tsakalakos, T. and Hilliard, J.E., J. Appl. Phys. 54, 734 (1983)Google Scholar
5. Baral, D., Ketterson, J.B. and Hilliard, J.E., J. Appl. Phys. 57, 1076 (1985)Google Scholar
6. Jankowski, A. and Tsakalakos, T., J. Appl. Phys. 51, 1835 (1985)Google Scholar
7. Jankowski, A., Makowiecki, D.M., McKernan, M.A., Nutt, S.R. and Green, K., Mat. Res. Soc. Symp. Proc. 103, 327 (1988)Google Scholar
8. Jankowski, A.F. in Superlattices and Microstructures, 6(4) 427 (1989)Google Scholar
9. Weihs, T.P., Hong, S., Bravman, J.C. and Nix, W.D., J. Mater Res. 3, 931 (1985)Google Scholar
10. Wall, M.A. and Jankowski, A.F., Thin Solid Films, 181, 313 (1989)Google Scholar
11. Doerner, M.F. and Nix, W.D., J. Mater. Res. 1, 601 (1986)Google Scholar
12. Nutt, S.R., Green, K.A., Baker, S.P., Nix, W.D. and Jankowski, A., Mat. Res. Soc. Symp. Proc. 130, 129 (1989)Google Scholar
13. Weihs, T.P., PhD. Dissertation, Stanford University (1990)Google Scholar