Hostname: page-component-586b7cd67f-rcrh6 Total loading time: 0 Render date: 2024-12-01T04:09:31.692Z Has data issue: false hasContentIssue false
  • English
  • Français

Increased Osteoblast Adhesion on Nanograined Hydroxyapatite and Tricalcium Phosphate Calcium Titanate Composites

Published online by Cambridge University Press:  01 February 2011

Huinan Liu ,
Celaletdin Ergun ,
John W. Halloran  and
Thomas J. Webster
Huinan Liu
Affiliation:
[email protected], Brown University, Division of Engineering, 182 Hope Street,Box D, Providence, RI, 02912, United States, 401-863-3081, 401-863-2323
Celaletdin Ergun
Affiliation:
[email protected], Istanbul Technical University, Mechanical Engineering Department, Istanbul, 34437, Turkey
John W. Halloran
Affiliation:
[email protected], University of Michigan, Materials Science and Engineering, Ann Arbor, MI, 48109, United States
Thomas J. Webster
Affiliation:
[email protected], Brown University, Division of Engineering, 182 Hope Street, Providence, RI, 02912, United States
Get access

Abstract

Depending on the coating method utilized and subsequent heat treatments (such as through the use of plasma-spray deposition), inter-diffusion of atomic species across titanium (Ti) and hydroxyapatite (HA) coatings may result. These events may lead to structural and compositional changes that consequently cause unexpected HA phase transformations which may clearly influence the performance of an orthopedic implant. Thus, the objective of the present in vitro study was to compare the cytocompatibility properties of chemistries that may form at the Ti:HA interface, specifically HA, tricalcium phosphate (TCP), Ti doped HA, and those containing calcium titanate (CaTiO3). In doing so, results of this in vitro study showed that osteoblast adhesion increased with greater CaTiO3 substitutions in either HA or TCP. Specifically, osteoblast adhesion on HA and TCP composites with CaTiO3 was almost 4.5 times higher than over pure HA. Material characterization studies revealed that enhanced osteoblast adhesion on these compacts may be due to increasing shrinkage in the unit lattice parameters and consequent decrease in grain size. Although all CaTiO3 composites exhibited excellent osteoblast adhesion results, Ca9HPO4(PO4)5OH phase formation into TCP/CaTiO3 increased osteoblast adhesion the most; due to these reasons, these materials should be further studied for orthopedic applications.

Keywords

biomaterialcompositebone
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 950: Symposium D – Biosurfaces and Biointerfaces , 2006 , 0950-D15-20
Copyright
Copyright © Materials Research Society 2007

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

[1] Ergun, C., Doremus, R.H., Lanford, W.B., J. Biomed. Mater. Res. 65A, 336 (2003).Google Scholar
[2] Ribeiroa, C.C., Gibsond, I., Barbosaa, M.A., Biomaterials 27, 1749 (2006).Google Scholar
[3] Webster, T.J., Ergun, C., Doremus, R.H., Lanford, W.B., J. Biomed. Mater. Res. 67A, 975 (2003).Google Scholar
[4] Asami, K., Saito, K., Ohtsu, N., Nagata, S., Hanawa, T., Surface and Interface Analysis 35(5), 483 (2003).Google Scholar
[5] Ergun, C., Webster, T.J., Bizios, R., Doremus, R.H., J. Biomed. Mater. Res. 59(2), 305 (2002).Google Scholar
[6] Webster, T.J., Ergun, C., Doremus, R.H., Siegel, R.W., Bizios, R., Biomaterials 22, 1327 (2001).Google Scholar