Hostname: page-component-78c5997874-lj6df Total loading time: 0 Render date: 2024-11-02T23:20:07.550Z Has data issue: false hasContentIssue false
  • English
  • Français

High-Fluence Implantation of Erbium into Silicon-Germanium Alloys: Structural and Thermal Properties

Published online by Cambridge University Press:  17 March 2011

V. Touboltsev ,
J. Räisänen ,
E. Johnson ,
A. Johansen  and
L. Sarholt
V. Touboltsev
Affiliation:
Department of Physics, University of Jyväskylä, Jyväskylä, Finland
J. Räisänen
Affiliation:
Department of Physics, University of Jyväskylä, Jyväskylä, Finland
E. Johnson
Affiliation:
Ørsted Laboratory, Niels Bohr Institute, University of Copenhagen, Denmark
A. Johansen
Affiliation:
Ørsted Laboratory, Niels Bohr Institute, University of Copenhagen, Denmark
L. Sarholt
Affiliation:
Ørsted Laboratory, Niels Bohr Institute, University of Copenhagen, Denmark
Get access

Abstract

High-quality crystalline Si1-xGex (x=0.10 and 0.25) alloys were implanted with 70 keV Er+ ions at temperatures of 350°C and 550°C to a fluence of 1015 cm−2. In-situ Rutherford backscattering/channeling (RBS) analysis supplemented with transmission electron microscopy (TEM) showed that as-implanted alloys were in form of ternary solid solutions with a peak Er concentration of 1 at.% without any trace of Er-Si or Er-Ge precipitation.

In the samples implanted at 350°C Er atoms were found to be distributed randomly in the amorphous host matrix. Post-implantation annealing at different temperatures up to 600° showed that the solid phase epitaxial regrowth of the damaged layers strongly depends on both the Ge concentration in the alloys and the temperature of annealing. Along with the recrystallization of the damaged matrix, annealing was observed to induce simultaneous removal of nearly all the implanted Er as the recrystallization front progresses towards the surface.

In contrast, high temperature implantation at 550°C led to spontaneous recovery of the alloy crystallinity and incorporation of considerable fraction of implanted Er atoms on regular tetrahedral interstitial sites in the host lattice.

Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 647: Symposium O – Ion Beam Synthesis & Processing of Advanced Materials , 2000 , O11.26
Copyright
Copyright © Materials Research Society 2001

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Coffa, S., Franzò, G., Priolo, F., MRS Bulletin 23(4), 25 (1998).Google Scholar
2. Ennen, H., Schneider, J., Pomrenke, G. and Axmann, A., Appl. Phys. Lett. 43, 943 (1983).Google Scholar
3. Taguchi, A., Taniguchi, M. and Takhei, K., Appl. Phys. Lett. 60, 965 (1992).Google Scholar
4. Abstreiter, G., Brugger, H., Wolf, T., Zachai, R. and Zeller, C., in:Two-Dimensional Systems: Physics and Devices, edited by Bauer, G., Kucher, F. and Henrich, H., Springer Series in Solid State Science (Springer, Berlin, 1986) Vol. 67, p.130 and references therein.Google Scholar
5. Swanson, M.L. in: Handbook of Modern Ion Beam Materials Analysis, edited by Tesmer, J.R. and Nastasi, M. (MRS, Pittsburg, 1995) p.231.Google Scholar
6. Morita, K., Radiat. Effects 28, 65 (1976).Google Scholar
7. Massalski, T.B., Murray, J.L., Bennett, L.H., and Baker, H., Binary Alloy Phase Diagrams (Metals Park, Ohio: American Society for Metals 1986).Google Scholar
8. Bourdelle, K.K., Khodyrev, V.A., Johansen, A., Johnson, E., and Sarholt-Kristensen, L., Phys. Rev. B 50, 82 (1994).Google Scholar