Hostname: page-component-586b7cd67f-tf8b9 Total loading time: 0 Render date: 2024-11-28T14:23:08.362Z Has data issue: false hasContentIssue false
  • English
  • Français

The Corrosion Behavior of Nickel-base Austenitic Alloys for Nuclear Hydrogen Generation

Published online by Cambridge University Press:  01 February 2011

Rama S Koripelli ,
Joydeep Pal  and
Ajit K Roy
Rama S Koripelli
Affiliation:
[email protected], UNLV, Mechanical Engineering, 1600E Rochelle Ave, apt 301, las vegas, NV, 89119, United States, 7022807297
Joydeep Pal
Affiliation:
[email protected], UNLV, Mechanical Engineering, 1600E Rochelle Ave, apt 301, las vegas, NV, 89119, United States, 7022807297
Ajit K Roy
Affiliation:
[email protected], UNLV, Mechanical Engineering, 1600E Rochelle Ave, apt 301, las vegas, NV, 89119, United States, 7022807297
Get access

Abstract

Three nickel-base austenitic alloys, namely Alloy C-22, Alloy C-276 and Waspaloy have been tested for evaluation of their corrosion resistance in an acidic solution at ambient and elevated temperatures. The results of stress corrosion cracking studies indicate that none of these materials did exhibit any failure at constant load. The cracking susceptibility determined by the slow strain rate technique was gradually enhanced at higher temperatures showing reduced ductility and true failure stress. The critical potentials determined by the polarization technique, became more active (negative) with increasing temperature. The fractograpic evaluations by scanning electron microscopy (SEM) revealed ductile failure in Alloys C-22 and C-276. However, Waspaloy showed brittle failure at elevated temperature.

Keywords

corrosionscanning electron microscopy (SEM)optical metallography
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 929: Symposium II – Materials in Extreme Environments , 2006 , 0929-II05-06
Copyright
Copyright © Materials Research Society 2006

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. March, J.L., Ruprecht, W. J., and Reed, George, “Machining of Notched Tension Specimens” ASTM Bulletin, ASTBA, Am.Soc.Testing Mats., No.244, 1960, pp.52–55.Google Scholar
2. ASTM Designation G129-00, “Standard Practice for Slow Strain Rate Testing to Evaluate the Susceptibility of Metallic Materials to Environmentally Assisted Cracking” American Society for Testing and Materials (ASTM) International.Google Scholar
3. ASTM Designation G38-01, “Standard Practice for Making and Using C-Ring Stress-Corrosion Test Specimens” American Society for Testing and Materials (ASTM) International.Google Scholar
4. ASTM Designation G30-97, “Standard Practice for Making and Using U-Bend Stress-Corrosion Test Specimens” American Society for Testing and Materials (ASTM) International.Google Scholar
5. ASTM Designation: G61-78, “Standard Practice for Conducting Cyclic Potentiodynamic Polarization Measurements for Localized Corrosion”, American Society for Testing and Materials (ASTM) International.Google Scholar