Hostname: page-component-586b7cd67f-gb8f7 Total loading time: 0 Render date: 2024-11-24T11:57:35.609Z Has data issue: false hasContentIssue false
  • English
  • Français

Characterization of Thin-film Thermoelectric Micro-modules using Transient Harman ZT Measurement and Near-IR Thermoreflectance

Published online by Cambridge University Press:  01 February 2011

Rajeev Singh ,
James Christofferson ,
Zhixi Bian ,
Joachim Nurnus ,
Axel Schubert  and
Ali Shakouri
Rajeev Singh
Affiliation:
[email protected], University of California, Santa Cruz, Electrical Engineering, SOE GRAD, 1156 High St., Santa Cruz, CA, 95064, United States
James Christofferson
Affiliation:
[email protected], University of California, Electrical Engineering Department, Santa Cruz, CA, 95064, United States
Zhixi Bian
Affiliation:
[email protected], University of California, Electrical Engineering Department, Santa Cruz, CA, 95064, United States
Joachim Nurnus
Affiliation:
[email protected], Micropelt GmbH, Freiburg, Germany
Axel Schubert
Affiliation:
[email protected], Micropelt GmbH, Freiburg, Germany
Ali Shakouri
Affiliation:
[email protected], University of California, Electrical Engineering Department, Santa Cruz, CA, 95064, United States
Get access

Abstract

We characterize several thin film thermoelectric micro-modules composed of 20 µm-thick elements and designed for cooling applications to identify factors that may limit device performance. Thermoelectric figure-of-merit measurements using the transient Harman technique are compared with maximum cooling data under no heat load. Correlation between the two measurements depending on the location of the parasitic joule heating in the module is analyzed. Near-infrared thermoreflectance is used to examine temperature non-uniformity in the module. The temperature distribution on the metal contacts due to the Peltier and Joule effects is obtained non-destructively through the silicon substrate of an active module.

Keywords

thermoelectricitythin filmpackaging
Type
Research Article
Information
MRS Online Proceedings Library (OPL) , Volume 1044: Symposium U – Thermoelectric Power Generation , 2007 , 1044-U10-01
Copyright
Copyright © Materials Research Society 2008

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Min, G. and Rowe, D. M. “Improved model for calculating the coefficient of performance of a Peltier module.” Energy Conversion and Management 41 (2000): 163–171.Google Scholar
2. Harman, T. C, Cahn, J. H and Logan, M. J. “Measurement of Thermal Conductivity by Utilization of the Peltier Effect.” Journal of Applied Physics 30 (1959): 1351–1359.Google Scholar
3. Singh, R., Bian, Z., Zeng, G., Zide, J., Christofferson, J., Chou, H., Gossard, A., Bowers, J., and Shakouri, A.. Transient Harman Measurement of the Cross-plane ZT of InGaAs/InGaAlAs Superlattices with Embedded ErAs Nanoparticles. Materials Research Society Symposium Proceedings, December, 2005, Boston, MA, USA.Google Scholar
4. Rosencwaig, A., Opsal, J., Smith, W. L, and Willenborg, D. L. “Detection of thermal waves through optical reflectance.” Applied Physics Letters 46 (1985): 1013–1015.Google Scholar
5. Bian, Z., and Shakouri, A.. “Beating the maximum cooling limit with graded thermoelectric materials.” Applied Physics Letters 89 (2006): 212101–1 .Google Scholar
6. Grauby, S., Forget, B. C, Hole, S., and Fournier, D.. “High resolution photothermal imaging of high frequency phenomena using a visible charge coupled device camera associated with a multichannel lock-in scheme.” Review of Scientific Instruments 70. 9 (1999): 3603–3608.Google Scholar