Hostname: page-component-cd9895bd7-p9bg8 Total loading time: 0 Render date: 2024-12-26T20:07:55.723Z Has data issue: false hasContentIssue false

Three-Dimensional Semiconductor Device Investigation Using Focused Ion Beam and Scanning Electron Microscopy Imaging (FIB/SEM Tomography)

Published online by Cambridge University Press:  25 January 2013

K. Lepinay*
Affiliation:
STMicroelectronics, 850 rue Jean Monnet, F-38926 Crolles, France
F. Lorut
Affiliation:
STMicroelectronics, 850 rue Jean Monnet, F-38926 Crolles, France
*
*Corresponding author. E-mail: [email protected]
Get access

Abstract

Three-dimensional focused ion beam/scanning electron microscopy (FIB/SEM tomography) is currently an important technique to characterize in 3D a complex semiconductor device or a specific failure. However, the industrial context demands low turnaround time making the technique less useful. To make it more attractive, the following study focuses on a specific methodology going from sample preparation to the final volume reconstruction to reduce the global time analysis while keeping reliable results. The FIB/SEM parameters available will be first analyzed to acquire a relevant dataset in a reasonable time (few hours). Then, a new alignment strategy based on specific alignment marks [using tetraethoxylisane (TEOS) and Pt deposition] is proposed to improve the volume reconstruction speed. These points combined represent a considerable improvement regarding the reliability of the results and the time consumption (gain of factor 3). This method is then applied to various case studies illustrating the benefits of the FIB/SEM tomography technique such as the precise identification of the origin of 3D defects, or the capability to perform a virtual top-down deprocessing on soft material not possible by any mechanical solution.

Keywords

Type
Software, Techniques and Equipment Development
Copyright
Copyright © Microscopy Society of America 2013

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Frank, T., Chappaz, C., Leduc, P., Arnaud, L., Lorut, F., Moreau, S., Thuaire, A., El Farhane, R. & Anghel, L. (2011). Resistance increase due to electromigration induced depletion under TSV. 2011 IEEE International, pp. 3F.4.13F.4.6. New York: IEEE.Google Scholar
Giannuzzi, L.A. & Stevie, F.A. (2005). Introduction to Focused Ion Beams. New York: Springer.CrossRefGoogle Scholar
Groeber, M.A., Haley, B.K., Uchic, M.D., Dimiduk, D.M. & Ghosh, S. (2006). 3D reconstruction and characterization of polycrystalline microstructures using a FIB–SEM system. Mater Charact 57, 259273.CrossRefGoogle Scholar
Lasagni, F.A., Lasagni, A.F., Huertas-Olivares, I., Holazapfel, C. & Mücklich, F. (2010). 3D nano-characterisation of materials by FIB-SEI/EDS tomography. IOP Conf Ser: Mater Sci Eng 7, 012016. Google Scholar
Lifshin, E., Evertsen, J., Principe, E. & Friel, J. (2005). Three dimensional imaging of microelectronic devices using a crossbeam FIB. Proceedings of the 12th International Symposium on the Physical and Failure Analysis of Integrated Circuits, IPFA 2005, p. 3. New York: IEEE.Google Scholar
Principe, E.L. & Sobol, P.E. (2005). High-density FIB-SEM tomogrpahy via real-time imaging. Microsc Microanal 11(Suppl 2), 322323.CrossRefGoogle Scholar
Ritter, M. & Midgley, P.A. (2010). A practical approach to test the scope of FIB-SEM 3D reconstruction. J Phys Conf Ser 241, 012081. Google Scholar
Steigerwald, M. (2003). New detection system for LEO FE-SEM. Oberkochen, Germany: Carl Zeiss. Available at www.zeiss.de.Google Scholar
Van Leer, B. & Giannuzzi, L. (2007). Static vs. dynamic FIB/SEM methods for 3D modeling. Microsc Microanal 13(Suppl 2), 10561057.Google Scholar
Yeoh, T.S., Ives, N.A., Presser, N., Stupian, G.W., Leung, M.S., McCollum, J.L. & Hawley, F.W. (2007). Focused ion beam tomography of a microelectronic device with sub-2-nm resolution. J Vac Sci Technol B 25(3), 922926.Google Scholar