Hostname: page-component-586b7cd67f-g8jcs Total loading time: 0 Render date: 2024-12-01T00:19:30.448Z Has data issue: false hasContentIssue false
  • English
  • Français

A Shield for Reducing the Thermal Signal from Heating Holders During In Situ Energy-Dispersive X-Ray Spectroscopy Analysis

Published online by Cambridge University Press:  16 July 2007

Santhana K. Eswaramoorthy ,
James M. Howe  and
Fritz Phillipp
Santhana K. Eswaramoorthy
Affiliation:
Department of Materials Science and Engineering, University of Virginia, Charlottesville, VA 22903-4745, USA
James M. Howe
Affiliation:
Department of Materials Science and Engineering, University of Virginia, Charlottesville, VA 22903-4745, USA
Fritz Phillipp
Affiliation:
Max-Plank-Institut für Metallforschung, Heisenbergstr. 3, Stuttgart, 70569, Germany
Get access

Abstract

This article describes a simple shield that can be placed on typical commercial heating holders to reduce the thermal signal during heating to reasonable levels for in situ energy-dispersive X-ray spectroscopy analysis. The improved temperature capability provided by the shield is demonstrated by initial compositional analysis results obtained across a solid–liquid interface on Al-Si-Cu-Mg alloy powder particles. Considerations in the design of and improvement for the shield are discussed.

Keywords

in situ TEMheating holderthermal shieldEDXSsolid–liquid interface
Type
MATERIALS APPLICATIONS
Information
Microscopy and Microanalysis , Volume 13 , Issue 4 , August 2007 , pp. 291 - 295
Copyright
© 2007 Microscopy Society of America

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

REFERENCES

Kamino, T., Sasaki, K. & Saka, H. (1997). High resolution electron microscopy in situ observation of dynamic behavior of grain boundaries and interfaces at very high temperatures. Microsc Microanal 3, 393–408.Google Scholar
Murray, J.L. & McAlister, A.J. (1984). The Al–Si (aluminum–silicon) system. Bull Alloy Phase Diagrams 5, 74–84.Google Scholar
Storaska, G.A. & Howe, J.M. (2004). In-situ transmission electron microscopy investigation of surface-oxide, stress-relief mechanisms during melting of sub-micrometer Al–Si alloy particles. Mater Sci Eng A368, 183–190.Google Scholar
Valimet, Inc. (2004). Home page available at: http://www.valimet.com/.