No CrossRef data available.
Article contents
Étude des performances de machines-outils 5 axes à structure parallèle et sérielle pour l’usinage d’une pièce aéronautique
Published online by Cambridge University Press: 15 September 2011
Abstract
L’utilisation de machines-outils à structure parallèle devrait permettre d’accroître la productivité de l’usinage par rapport aux machines-outils à structure sérielle pour des performances cinématiques des axes similaires. Ces machines-outils doivent cependant présenter une rigidité de leur structure, une précision de leur commande, et une accessibilité d’outil suffisantes pour l’usinage de pièces aéronautiques. Cet article propose alors de comparer les performances durant l’usinage d’une machine-outil 5 axes à structure parallèle, la Tripteor X7 de PCI, et d’une machine-outil 5 axes à structure sérielle, la KX15 de Huron. La comparaison est réalisée à l’aide d’une pièce test représentative du secteur aéronautique. Les paramètres évalués sont le temps d’usinage pour les différentes opérations, la qualité dimensionnelle et géométrique de la pièce réalisée et l’état de surface des surfaces obtenues. Ces essais illustrent le potentiel des machines-outils à structure parallèle à usiner des pièces aéronautiques avec une qualité dimensionnelle et géométrique satisfaisante en augmentant la productivité. Cependant, la qualité d’état de surface obtenue avec la machine-outil à structure parallèle PCI Tripteor X7 n’est pas acceptable vis-à-vis des contraintes de qualité des pièces aéronautiques. Ainsi, plusieurs voies d’amélioration du processus d’usinage avec les machines-outils à structure parallèle sont proposées afin de mieux maîtriser la productivité et l’état de surface obtenue durant l’usinage.
Keywords
- Type
- Research Article
- Information
- Copyright
- © AFM, EDP Sciences 2011