Hostname: page-component-586b7cd67f-dlnhk Total loading time: 0 Render date: 2024-11-28T08:47:53.743Z Has data issue: false hasContentIssue false
  • English
  • Français

An experimental study of edge effects on rotating-disk transition

Published online by Cambridge University Press:  28 January 2013

Shintaro Imayama ,
P. Henrik Alfredsson  and
R. J. Lingwood
Shintaro Imayama*
Affiliation:
Linné Flow Centre, KTH Mechanics, SE-100 44 Stockholm, Sweden
P. Henrik Alfredsson
Affiliation:
Linné Flow Centre, KTH Mechanics, SE-100 44 Stockholm, Sweden
R. J. Lingwood
Affiliation:
Linné Flow Centre, KTH Mechanics, SE-100 44 Stockholm, Sweden Institute of Continuing Education, University of Cambridge, Madingley Hall, Madingley, Cambridge CB23 8AQ, UK
*
†Email address for correspondence: [email protected]
Get access Rights & Permissions [Opens in a new window]

Abstract

The onset of transition for the rotating-disk flow was identified by Lingwood (J. Fluid. Mech., vol. 299, 1995, pp. 17–33) as being highly reproducible, which motivated her to look for absolute instability of the boundary-layer flow; the flow was found to be locally absolutely unstable above a Reynolds number of 507. Global instability, if associated with laminar–turbulent transition, implies that the onset of transition should be highly repeatable across different experimental facilities. While it has previously been shown that local absolute instability does not necessarily lead to linear global instability: Healey (J. Fluid. Mech., vol. 663, 2010, pp. 148–159) has shown, using the linearized complex Ginzburg–Landau equation, that if the finite nature of the flow domain is accounted for, then local absolute instability can give rise to linear global instability and lead directly to a nonlinear global mode. Healey (J. Fluid. Mech., vol. 663, 2010, pp. 148–159) also showed that there is a weak stabilizing effect as the steep front to the nonlinear global mode approaches the edge of the disk, and suggested that this might explain some reports of slightly higher transition Reynolds numbers, when located close to the edge. Here we look closely at the effects the edge of the disk have on laminar–turbulent transition of the rotating-disk boundary-layer flow. We present data for three different edge configurations and various edge Reynolds numbers, which show no obvious variation in the transition Reynolds number due to proximity to the edge of the disk. These data, together with the application (as far as possible) of a consistent definition for the onset of transition to others’ results, reduce the already relatively small scatter in reported transition Reynolds numbers, suggesting even greater reproducibility than previously thought for ‘clean’ disk experiments. The present results suggest that the finite nature of the disk, present in all real experiments, may indeed, as Healey (J. Fluid. Mech., vol. 663, 2010, pp. 148–159) suggests, lead to linear global instability as a first step in the onset of transition but we have not been able to verify a correlation between the transition Reynolds number and edge Reynolds number.

JFM classification

Instability: Absolute/convective instability Boundary Layers: Boundary layer stability Instability: Transition to turbulence
Type
Papers
Information
Journal of Fluid Mechanics , Volume 716 , 10 February 2013 , pp. 638 - 657
Copyright
©2013 Cambridge University Press

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

Chin, D.-T. & Litt, M. 1972 An electrochemical study of flow instability on a rotating disk. J. Fluid Mech. 54, 613–625.CrossRefGoogle Scholar
Clarkson, M. H., Chin, S. C. & Shacter, P. 1980 Flow visualization of inflexional instabilities on a rotating disk. AIAA Paper 80-0279.CrossRefGoogle Scholar
Cobb, E. C. & Saunders, O. A. 1956 Heat transfer from a rotating disk. Proc. R. Soc. Lond. Math. A 236, 343–351.Google Scholar
Davies, C. & Carpenter, P. W. 2003 Global behaviour corresponding to the absolute instability of the rotating-disc boundary layer. J. Fluid Mech. 486, 287–329.CrossRefGoogle Scholar
Fedorov, B. I., Plavnik, G. Z., Prokhorov, I. V. & Zhukhovitskii, L. G. 1976 Transitional flow conditions on a rotating disk. J. Engng Phys. Thermophys. 31, 1448–1453.Google Scholar
Gregory, N., Stuart, J. T. & Walker, W. S. 1955 On the stability of three-dimensional boundary layers with application to the flow due to a rotating disk. Phil. Trans. R. Soc. Lond. 248, 155–199.Google Scholar
Gregory, N & Walker, W. S. 1960 Experiments on the effect of suction on the flow due to a rotating disk. J. Fluid Mech. 9, 225–234.CrossRefGoogle Scholar
Healey, J. J. 2010 Model for unstable global modes in the rotating-disk boundary layer. J. Fluid Mech. 663, 148–159.Google Scholar
Huerre, P. & Monkewitz, P. A. 1990 Local and global instabilities in spatially developing flows. Annu. Rev. Fluid Mech. 22, 473–537.Google Scholar
Imayama, S., Alfredsson, P. H. & Lingwood, R. J. 2012 A new way to describe the transition characteristics of a rotating-disk boundary-layer flow. Phys. Fluids 24, 031701.Google Scholar
Johansson, A. V. & Alfredsson, P. H. 1982 On the structure of turbulent channel flow. J. Fluid Mech. 122, 295–314.CrossRefGoogle Scholar
von Kármán, T. 1921 Über laminare und turbulent Reibung. Z. Angew. Math. Mech. 1, 233–252.Google Scholar
Kobayashi, R., Kohama, Y. & Takamadate, C. 1980 Spiral vortices in boundary layer transition regime on a rotating disk. Acta Mech. 35, 71–82.CrossRefGoogle Scholar
Kohama, Y. 1984 Study on boundary layer transition of a rotating disk. Acta Mech. 50, 193–199.Google Scholar
Le Gal, P. 1992 Complex demodulation applied to the transition to turbulence of the flow over a rotating disk. Phys. Fluids A 4, 2523.CrossRefGoogle Scholar
Lingwood, R. J. 1995 Absolute instability of the boundary layer on a rotating disk. J. Fluid Mech. 299, 17–33.CrossRefGoogle Scholar
Lingwood, R. J. 1996 An experimental study of absolute instability of the rotating-disk boundary-layer flow. J. Fluid Mech. 314, 373–405.Google Scholar
Lingwood, R. J. 1997 Absolute instability of the Ekman layer and related rotating flows. J. Fluid Mech. 331, 405–428.Google Scholar
Lingwood, R. J. & Garrett, S. J. 2011 The effects of surface mass flux on the instability of the BEK system of rotating boundary-layer flows. Eur. J. Mech. (B/Fluids) 30, 299–310.Google Scholar
Malik, M. R., Wilkinson, S. P. & Orszag, S. A. 1981 Instability and transition in rotating disk flow. AIAA J. 19, 1131–1138.Google Scholar
Othman, H. & Corke, T. C. 2006 Experimental investigation of absolute instability of a rotating-disk boundary layer. J. Fluid Mech. 565, 63–94.CrossRefGoogle Scholar
Pier, B. 2003 Finite-amplitude crossflow vortices, secondary instability and transition in the rotating-disk boundary layer. J. Fluid Mech. 487, 315–343.Google Scholar
Smith, N. H. 1947 Exploratory investigation of laminar-boundary-layer oscillations on a rotating disk. NACA TN 1227.Google Scholar
Theodorsen, T. & Regier, A. A. 1944 Experiments on drag of revolving disks, cylinders and streamline rods at high speeds. NACA Rep. 793.Google Scholar
Viaud, B., Serre, E. & Chomaz, J.-M. 2011 Transition to turbulence through steep global-modes cascade in an open rotating cavity. J. Fluid Mech. 688, 493–506.Google Scholar
Wilkinson, S. P. & Malik, M. R. 1985 Stability experiments in the flow over a rotating disk. AIAA J. 23, 588–595.Google Scholar