Hostname: page-component-586b7cd67f-r5fsc Total loading time: 0 Render date: 2024-11-27T17:30:53.641Z Has data issue: false hasContentIssue false
  • English
  • Français

The Compression of Circular Rings

Published online by Cambridge University Press:  28 July 2016

W. Johnson
W. Johnson*
Affiliation:
Department of Mechanical Engineering, University of Sheffield
Get access Rights & Permissions [Opens in a new window]

Extract

Assuming the formation of plastic hinges at the quarter points of a ring subject to a diametral compressive force, a comparison is made between experimental collapse loads and those predicted by use of a simple expression based on the use of plastic rectangular stress blocks, for some common materials; good correlation is obtained with aluminium.

A member may be said to fail when it yields completely at several positions and so allows collapse as a mechanism to occur. The smallest load at which this happens marks the end of useful life of the member. In the case of very thin rings loaded at the ends of a diameter in compression, as shown in Fig. 1, it is obvious that the sections of greatest bending moment are at A, B, C and D. These moments will continue to increase with increasing diametral load.

Type
Technical Notes
Information
The Aeronautical Journal , Volume 60 , Issue 547 , July 1956 , pp. 484 - 487
Copyright
Copyright © Royal Aeronautical Society 1956

Access options

Get access to the full version of this content by using one of the access options below. (Log in options will check for institutional or personal access. Content may require purchase if you do not have access.)

References

1. Hwang, C. (1953). Plastic Collapse of Thin Rings. Journal of the Aeronautical Sciences, p. 819, December 1953.CrossRefGoogle Scholar
2. Greenberg, H. J. and Prager, W. (1951). Proc. A.S.C.E., Vol. 17, February 1951.Google Scholar
3. Johnson, W. Unpublished work.Google Scholar